FRONT-PANEL CONTROLS
| ¸ | ˘ | ¯ | ˜ | ˆ | ı | Ù | Û Ú | |
|
| DIGITAL | LOGIC 7 |
|
| VID 1 | DVD |
|
|
|
| PRO LOGIC |
|
|
| VID 2 | CD |
|
|
|
| 3 STEREO | DSP |
|
| VID 3 | FMAM |
|
|
|
|
| 5 CH. STEREO |
|
| VID 4 | TAPE |
|
|
|
|
| SURR. OFF |
|
|
| 6 8 CH |
|
|
1 3 | 5 | 7 |
| 9 ! # % |
| & | ( |
| Ô Ò |
2 | 4 | 6 | 8 | ) @ ) $ | ^ |
| * | Ó | |
NOTE: To make it easier to follow the instructions that refer to this illustration, a larger copy may be downloaded from the Product Support section for this product at www.harmankardon.com.
1Main Power Switch
2 Power Indicator
3 Standby/On Switch
4 Headphone Jack
5 Tone Mode
6 Speaker Selector
7 Surround Mode Group Selector
8 Surround Mode Selector
9 Tuning Selector ) ‹/› Buttons
! Tuner Band Selector
1Main Power Switch: Press this button to apply power to the AVR 230. When the switch is pressed in, the unit is in a Standby mode, as indicated by the amber LED 2 above the Standby/On Switch 3. This button MUST be pressed in to operate the unit. To turn the unit off and prevent the use of the remote control, this switch should be pressed until it pops out from the front panel and the word “OFF” is seen at the top of the switch.
NOTE: This switch is normally left in the “ON” position.
2Power Indicator: This LED lights amber when the unit is in the Standby mode to signal that the AVR is ready to be turned on. When the unit is in operation, the indicator is blue.
@Set Button
#Digital Input Selector $ Preset Station Selector % Delay Adjust Selector ^ Input Source Selector & Tuner Mode Selector * Optical 3 Digital Input ( Coaxial 3 Digital Input Ó Video 4 Video Input Jacks Ô Video 4 Audio Input Jacks Bass Control
3Standby/On Switch: When the Main Power Switch 1 is “ON,” press this button to turn on the
AVR 230; press it again to turn the unit off. The Power Indicator 3 turns blue when the unit is on.
4Headphone Jack: This jack may be used to listen to the AVR 230’s output through a pair of headphones. The speakers will automatically be turned off when the headphone jack is in use.
5Tone Mode: Pressing this button enables or dis- ables the Bass and Treble tone controls. When the but- ton is pressed so that TONE IN appears in the Lower Display Line ¯, the Bass and Treble
Ú controls may be used to adjust the output signals. When the button is pressed once or twice so that the words TONE OUT appear in the Lower Display Line ¯, the output signal will be “flat,” no matter how the actual Bass and Treble Controls Ú are adjusted.
ÒBalance Control Ú Treble Control
Û Channel Adjust Selector Ù Volume Control
ı Input Indicators
ˆ Speaker/Channel Input Indicators ˜ Upper Display Line
¯ Lower Display Line
˘ Surround Mode Indicators ¸ Remote Sensor Window
6Speaker Selector: Press this button to begin the process of configuring the unit to match the type of speakers used in your listening room. (See pages
7Surround Mode Group Selector: Press this but- ton to select the
