INSTALLATION
STEP NINE – Install a Multizone System
The AVR 3600 offers several methods of distributing audio to other areas in your home.
IMPORTANT SAFETY NOTE: Installing a multizone system typically requires running cables inside walls. Always comply with the appropriate safety codes when installing con- cealed wiring, particularly all applicable state and local build- ing codes and the NEC (National Electrical Code). Failure to do so may present a safety hazard. If you have any doubt about your ability to work with electrical and telecommunications wiring, hire a licensed electrician or custom installer to install the multizone system.
When the system is installed using methods B or C below, multizone operation takes over the Surround Back/ Zone 2 amplifier channels, limiting the system in the main listening room to 5.1 channels.
Select one or all of these methods for audio distribution:
A. Connect an external amplifier to the Zone 2 Audio Outputs. It is recommended that you place the amplifier in the same room as the AVR 3600 so that a shorter length of inter- connect cable is used with a long run of speaker wire to the remote room. A long run of interconnect cable would be subject to signal degradation. Depending on your amplifier, distribute the audio sig- nal to a single pair of speakers, or to several pairs placed in differ- ent rooms.
The Zone 2 Audio Outputs offer the benefit of
B. Connect the remote room’s speakers directly to the Surround Back/Zone 2 Speaker Outputs. Reassign the Surround Back amplifier channels to power the speakers (see page 47).
Your main system will be limited to 5.1 channels, affecting playback of programs recorded in 6.1 or 7.1 channels.
C. Connect an external amplifier to the Surround Back/Zone 2 Preamp Outputs. This method requires an additional amplifier, but may increase the total number of remote rooms when used with methods A and B.
D.Connect an
IR commands received from the
Connect IR Control Devices to the Zone 2 IR Input
For methods A, B and C, connect an IR control device to the Zone 2 IR Input for
NOTE: Only analog audio sources are available to the multi- zone system. For digital sources, make a second, analog audio connection. The Bridge III source is available to the multizone system.
STEP TEN – Plug in AC Power Cords
Before plugging the AVR into an unswitched electrical outlet, make sure the Main Power Switch on the
You may plug one device that draws no more than 50 watts into the AC Switched Accessory Outlet on the rear panel. Turn on the device’s mechanical or master power switch, and that device will power on any time the AVR 3600 is turned on (some devices may require additional steps to power on from their standby mode). If the device has a clock or must always be on (such as a cable
The AVR 3600 is equipped with a detachable power cord, allowing you to fully wire your system before installing the AVR. Plug the male end of the cord into an unswitched AC outlet, and the female end into the AVR 3600.
It is recommended that you copy the appropriate information from the Table 2 worksheet to Table A5 in the appendix for future refer- ence, in the event changes are made to the system components.
STEP ELEVEN – Insert Batteries in Remote
The AVR 3600 remote control uses four AAA batteries (included).
To remove the battery cover located on the back of the remote, squeeze the tab and lift the cover.
Insert the batteries as shown in Figure 17, observing the correct polarity.
Figure 17 – Remote Battery Compartment
Point the remote’s lens toward the front panel of the AVR 3600. Make sure no objects, such as furniture, are blocking the remote’s path to the receiver. Bright lights, fluorescent lights and plasma video displays may interfere with the remote’s functioning. The remote has a range of about 20 feet, depending on the lighting conditions. It may be used at an angle of up to 30 degrees to either side of the AVR.
25
