INITIAL SETUP
NOTE: The AVR 3600 will automatically set its master volume to – 25dB.
STEP FOUR – After you select “Continue”, the screen shown in Figure 22 will appear. Select the number of speakers in your system. Select 5.1 if no surround back speakers are present, or if the surround back channels will be used for multizone operation.
established by the EzSet/EQ process.
Set Up Sources
The Info Settings menu is used to assign the correct physical audio and video connections to each source.
The following settings are not optional and must be adjusted now to enable playback of each source: Video Input From Source, Audio Input From Source and Resolution to Display. The other settings may be adjusted later.
To display the Info Settings menu, press the Info Settings Button (front panel or remote). Or, from the Main Menu, select the Setup Source line and select a source from the
Figure 22 – EzSet/EQ: Number of Speakers
NOTE: If there are fewer than five main speakers in your system, do not use the EzSet/EQ process. Instead, proceed as described in the Advanced Functions section. If you have selected a
5.1speakers, connect the single surround back speaker to the left Surround Back Speaker Output, then configure the surround back speaker manually, as described in the Advanced Functions section. The
The test will begin, and the screen shown in Figure 23 will appear. Maintain silence during the EzSet/EQ configuration.
Figure 23 – EzSet/EQ in Progress
As EzSet/EQ tests each speaker, its position will appear on screen. If the test sweep is heard from a different speaker than the one indicated on screen, turn off the AVR and check the
When the test is completed, select the Continue option. The results will be displayed, along with these options:
•The Retest option repeats the EzSet/EQ process. Increase the master volume manually if some speakers were not correctly detected.
•Select Cancel to return to the Speaker Setup menu.
See the Advanced Functions section for instructions on how to manually configure the speakers or manually adjust the settings
Figure 24 – Setup Source Menu
Audio Effects: Displays the Audio Effects submenu, where you may adjust the Dolby Volume setting, the bass and treble tone controls, the LFE trim and the MP3 enhancement for each source independently. Leave this submenu at its default settings, and return to it later if your system requires
Video Modes: Displays the Video Modes submenu, where you may make picture adjustments for each source independently. Leave the settings at their factory defaults. Picture adjustments should be made to your video display first, with this menu used only for fine- tuning. See the Advanced Functions section for more information.
Surround Modes: Displays the Surround Modes submenu, where you may program surround modes for movies, music and games for each source independently.
Digital surround signals, such as Dolby Digital and DTS, are auto- matically played in their native formats, although you may change the surround mode. See the Advanced Functions section for more information.
Audio Format From Source: This line is informational only. When a digital program is playing, its format will be identified here. When analog audio programs are playing, this line displays
ANALOG.
Audio and Video Input Selection
See Table A2 in the appendix for the factory default input assignments for each source. You may assign any available input to any source using the Info Settings menu.
When a source is selected, the AVR will check the assigned digital audio input for a signal. If one is present, the digital input will be
29
