Harman-Kardon TU 970 owner manual Rear Panel Connections, Analog Audio Outputs

Rear Panel Connections

Optical and Coaxial Digital Outputs	DAB Antenna
FM Antenna	AC Power Cord
AM Antenna	Remote Control Output
Analog Audio Outputs	Remote Control Input

Optical and Coaxial Digital Outputs: Connect one of these jacks to the optical or coaxial digital input of your pre amplifier or inte- grated amplifier, if available.

Note that these digital outputs only contain the digital signal from the DAB stations. For FM/AM reception, you will have to connect the analog outputs at all times.

FM Antenna: Connect an indoor or external FM antenna to this terminal.

AM Antenna: Connect the AM loop anten- na supplied with the receiver to these terminals. If an external AM antenna is used, make connec- tions to the AM and GND terminals in accor- dance with the instructions supplied with the antenna.

Analog Audio Outputs: Connect these jacks to the tuner input of your pre amplifier or integrated amplifier for analog audio playback. Be certain to observe proper channel connec- tions using the color-coded cables and connec- tors so that red connects right channels and white connects left channels.

NOTE: Before making any audio connections, unplug all components of your audio system from their AC power outlets. To reduce the possi- bility of hum or noise in your system, place all audio interconnection cables away from both AC power cords and speaker wires.

DAB Antenna: Connect a DAB antenna to this terminal.

AC Power Cord: Connect this plug to an AC outlet. If the outlet is controlled by a switch, make certain that it is in the ON position.

Remote Control Output: Connect this jack to the infrared (IR) input jack of another compatible Harman Kardon remote controlled product to have the built-in Remote Sensor on the tuner provide IR signals to other compatible products.

Remote Control Input: Connect the output of a remote infrared sensor, or the remote control output of another compatible Harman Kardon product, to this jack. This will enable the remote control to operate even when the front panel Remote Sensor on the tuner is blocked. This jack may also be used with compatible IR remote control-based automation systems.

REAR PANEL CONNECTIONS 5