SETUP AND CONNECTIONS
•Ensure that the power switch of this unit (and of other equipment to be connected) is set to “Off” before commencing connection.
•Do not block the ventilation holes of any of the equipment and arrange them so that air can circulate freely.
•Read through the instructions before connecting other equipment.
•Ensure that you observe the
Connecting to a TV and Analog Receiver
TV
| To |
To analog audio input connectors (red/white) on the | |
TV or analog receiver |
|
| NOTE: While we suggest the use of |
To video input | for higher quality pictures, you may also use |
the standard composite video connection if | |
connector (yellow) | your TV does not have an |
one video connection is needed, not both.
DVD 101
To power outlet (AC 120V/60Hz)
VIDEO OUT/COMPONENT
Y / Y
Pb/ Cb
DVD 101
120V/60Hz 20
CLASS | 1 | LASER PRODUCT |
| |
KLASSE |
| 1 | LASER PRODUKT | 1 |
LUOKAN | 1 | LASER LAITE | ||
KLASS | 1 | LASER APPARAT |
Pr/ Cr
NOTES:
•The video output (yellow) combines the complete video signal (composite) and sends it to the TV (or to the A/V receiver) by one cable only. Use the video output when your TV set is equipped with
a video input jack only.
•The S (separate) video output connector separates the color (C) and luminance (Y) signals before trans- mitting them to the TV set in order to achieve a
sharper picture. Use the
•When the audio signal is to be fed to an analog receiver rather than to the TV, connect the audio out jacks to any normal audio input on your amplifier/ decoder/receiver. The DVD 101 will “downmix”
Dolby Digital recordings to Pro Logic®, available on these connectors; all analog surround or stereo signals will be fed to them directly. You can also select the audio and video signals of all your video devices with your A/V receiver/amplifier. For more information see the “NOTE” on next page.