Harman Stove Company 1-90-797000 manual An Approved Canadian Wall Pass-Through, D. The Chimney

Oakleaf Woodburning Stove

	Non-combustible cover, one
	side only. If two covers are
Hole with a minimum	used, each must be mounted
clearance of 18" (450 mm)	on non-combustible spacers
between connector and wall.	at least 7/8" (21mm) away
	from the wall.

1" (25mm) Clearance

AN APPROVED CANADIAN

WALL PASS-THROUGH

Closest	Minimum 2" (50mm)
Combustible
Material	Clearance to Brick
	Liner	Minimum 12"
		(300mm) to Brick
	Flue	Fire Clay
		Thimble
	Chimney	Chimney

Connector

Masonry Chimney Built to

NFPA 211 Specifications.

Minimum 12" (300mm) to Combustibles

AN APPROVED U.S.

WALL PASS-THROUGH

D. The Chimney

This unit must be installed into a chimney approved for use with solid-fuel appliances. In the U.S., it must be connected to (1) a prefabricated chimney complying with the requirements for Type HT chimneys in the Standard for Chimneys, Factory-Built, Residential Type and Build- ing Heating Appliances, UL 103, or (2) a code-approved masonry chimney with a flue liner.

In Canada, this unit is listed for use with prefabricated chimneys tested and listed to the high temperature (650 degrees C) chimney standard, ULC S-629, or with a code approved masonry chimney.

Do not connect this unit to a chimney flue servicing another appliance.

NOTE: The restriction of not venting more than one appliance to the same flue applies to the U.S. specifically. While it is not recommended that you use the same chimney for more than one appliance, in Canada certain exceptions may be made. Be sure to contact your building code inspection official to see if this option is allowed in your area, and to find out the specific requirements for such an installation.

For mobile homes, (US only) it must only be installed with a factory built stainless steel chimney. The chimney system should include all required installation compo- nents, such as vapor barriers and roof flashing, as tested for use in mobile homes.

The minimum recommended height for any chimney is 16 ft. (4.8 m) above flue collar height. For non-mobile home installations, a round flue (either masonry or ap- proved prefabricated), of either 6" (150 mm), 7" (180 mm) or 8" (200 mm) may be used. For square or rectangular masonry chimneys, nominal sizes of 8" x 8" or 7" x 12" (200mm x 200 mm, 180 mm x 300 mm) may be used.

Codes require that solid-fuel chimneys extend 3 ft. (0.9

m) above the highest point at which they exit from the

roof. Then, the chimney must extend 2 ft. (0.6 m) above

More Than 10 ft. (3m)

10 ft. (3m)

2 ft. (0.6m) min.

Ridge

Chimney

Height Necessary Above Any Roof Sur- face Within 10ft. (3m)

3ft. (0.9m) minimum above exit

point

the highest point within a 10 ft (3 m) radius. Thus, the 3

foot, 2 foot, 10 foot rule:

3ft. - Above roof exit point

2ft. - Higher than anything within-

10ft. of the chimney.

The 3-foot, 2-foot, 10 foot rule

14 Dry Seasoned Wood Only! 3-90-798 Save These Instructions