Oakleaf Woodburning Stove

E. Pre- Use Check List

1.

 

Place the appliance in a location near the

 

 

final installation and follow the procedures

 

 

below:

2.

 

Open the appliance and remove all articles

 

 

packed inside. Inspect all items for shipping

 

 

damage. Notify dealer of any missing or

 

 

damaged goods.

3.

 

All safety warnings have been read and

 

 

followed precisely.

4.

 

This Owner's Manual has been read in it's

 

 

entirety.

5.

 

Floor protection requirements have been

 

 

read and followed.

6.

 

The flue connector has been installed in

 

 

accordance with the instructions herein.

7.

 

The proper clearances from the appliance

 

 

and chimney connector to combustibles

 

 

have been met.

8.

 

The masonry chimney has been cleaned

 

 

and inspected by a professional, or the

 

 

factory built metal chimney is installed

 

 

according to the manufacturers instructions.

9.

 

The chimney meets the minimum height

 

 

requirements.

10.

 

All labels and hang tags have been removed

 

 

from the glass.

11.

 

All plated surfaces have been wiped clean,

 

 

if applicable.

12.

 

The optional air distribution blower

 

 

has been installed properly.

13.

 

A properly grounded electrical receptacle is

 

 

available within reach of the blower's power

 

 

cord (if installed).

 

 

 

WARNING

Inspect appliance and components for damage. Damaged parts may impair safe operation.

Do NOT install damaged compo- nents.

Do NOT install incomplete com- ponents.

Do NOT install substitute com- ponents.

Report damaged parts to dealer.

WARNING

Fire Risk.

Hearth & Home Technologies disclaims any responsibility for, and the warranty will be voided by, the following actions:

Installation and use of any damaged appliance.

Modification of the appliance.

Installation other than as instructed by Hearth & Home Technologies.

Installation of parts or components not supplied or approved by Hearth & Home Technologies.

Operating appliance without the legs attached.

Operating appliance without fully assembling all components.

Do NOT Overfire.

Or any such action that may cause a fire hazard.

There are two brick clips located in the Owner’s manual bag. With the bricks in place, install the clips in the front corners as shown. The long portion of the clip will fit between the brick and the wall of the stove, with the short hook over-hanging to the inside of the firebox.

8 Dry Seasoned Wood Only!

3-90-798

Save These Instructions

Page 8
Image 8
Harman Stove Company 1-90-797000 manual Pre- Use Check List, Fire Risk