Harman Stove Company Conquest Gas Stove manual OPERATION5, Operation

OPERATION5

Piezo Ignitor

Button

High-Low

Gas Control

PILOT

Operation

HOW TO LIGHT THE FIRE

1.STOP! Read the safety information on the front cover of this manual.

2.If using the optional thermostat, set thermostat to the lowest setting.

3.Turn off electric power to the optional blower.

4.Turn the ON-OFF switch to the OFF position.

5.Push in the gas control knob slightly and turn it clockwise to "OFF." NOTE: THE KNOB CANNOT BE TURNED FROM "PILOT" TO "OFF" UNLESS IT IS PUSHED IN SLIGHTLY. DO NOT FORCE IT.

6.Wait five (5) minutes to clear out any gas. If you then smell gas, STOP! Follow "B" in the safety information on the front cover. If you don't smell gas, go to the next step.

7.Set the High-Low Regulator to High by turning it fully counterclockwise.

8.Press in the gas control knob slightly and turn counterclockwise to "PILOT."

9.Find the pilot by looking down between the logs as shown at lower left.

10.Push the control knob fully down and hold. Immediately push the red piezo ignitor button to light the pilot. It is normal to have to push the red button several times before the pilot ignites. Continue to hold the control knob in for about

one (1) minute after the pilot is lit. Release the knob and it will pop back up. Pilot should remain lit. If it goes out, repeat steps 5

through 10.

•If the knob does not pop up when re- leased, stop and immediately call your service

technician or gas supplier.

•If the pilot will not stay lit after several tries, turn the gas control knob to "OFF" and call your service technician or gas supplier.

11.Turn the gas control knob counterclockwise to "ON."

12.Place the ON-OFF switch in the ON position or turn up the thermostat setting if the optional thermostat is used.

13.Turn on the electric power to the optional blower if installed.

14.Set the optional thermostat to the desired room temperature.