6Mobile Home
TL2.0 Woodburning Stove
A. Mobile Home Installation
Mobile home approval - U.S. only.
DO NOT INSTALL IN A MOBILE HOME IN CANADA.
1.An outside air inlet must be provided for combustion air, and must remain clear of leaves, debris, ice, and/or snow. The outside air path must be unrestricted while the appliance is in operation. Use Kit
2.The combustion air intake system must be of metal construction. It must permit
3.The appliance must be secured to the mobile home structure by bolting it to the floor. There are holes provided in the pedestal base. Secure with the proper length lag bolts, through the hearth pad and into the home floor.
4.The appliance must be grounded to the metal framing of the mobile home
5.All clearances to combustibles and floor protection requirements must be followed.
6.Follow the vent manufacturer's instructions when installing in a mobile home. Must be connected to a UL103 HT ventillated chimney connector, UL103 HT chimney, and terminal cap with spark arrestor.
7.Use silicone to create an effective vapor barrier at the location where the chimney or other component penetrates to the exterior.
8.Installation shall be in accordance with the Manufactured Home and Safety Standard (HUD) CFR 3280, Part 24
9.The appliance must never be installed in a room designated for sleeping.
10.Burn wood only. Other fuels may generate poisonous gases (carbon monoxide).
11.If unit burns poorly while an exhaust blower (range hood) is operating, increase the supply of combustion air to the appliance
Caution
the structural integrity of the mobile home floor, wall and ceiling/roof must be maintained.
Do NOT cut through:
•Floor joist, wall studs, or ceiling trusses.
•Any supporting material that would affect the structural integrity.
NOTE: The top sections of the chimney must be removable to allow a maximum clearance of 13.5 feet (411cm) from ground level for transportation purposes.
| Chimney Cap |
Chimney | Storm Collar |
Sections | Roof Flashing |
| |
| Roof |
| Radiation |
Attic | Shield |
| |
Radiation |
|
Shield |
|
Minimum Air Space | Chimney |
with Chimney Listing | Support |
Chimney
Connector
Outside
Air
warning
Installation must comply with
Manufactured Home and Safety Standard
(HUD), CFR 3280, Part 24.
warning
Do not install in sleeping room.
20 Dry Seasoned Wood Only! | Save These Instructions |
