TL2.0 Woodburning Stove
D. Optional Blower Installation
Use ONLY Blower Part
The optional blower kit installs easily to the rear of the TL2.0. First, remove the air jacket shield from the rear of the stove. Use the same four bolts to attach the blower as shown.
E. Top Air Grill Option
The top air grill installs over the flue collar and simply rests on the top of the stove. The brushed stainless grill is included with this option as well.
F. Brushed Stainless Trim Kit Option
Warning
Route Power cord away from the appliance. Do not run the cord under or in front of the appliance.
Plug the blower into a properly grounded electrical outlet.
Keep the blower on low speed or off during low fires. As you get out of the low burn range, the speed can be set wherever desired, or kept off.
The trim kit consists of three pieces; Load door trim, Ash lip trim, and the Ash door frame. To install the load door trim, it is best to remove the door by lifting from the hinges. lay the door down flat on it's face. Drill the dimpled holes in each corner of the door and
22 Dry Seasoned Wood Only! | Save These Instructions |