Harman Stove Company TL2.0 manual General Maintenance Procedures, Ash Removal, By User

TL2.0 Woodburning Stove

B. General Maintenance Procedures

1.Ash Removal

•Frequency: As needed / Every day or two

•By: User

Wear Leather Gloves To Prevent Skin Burns!

Open the ash removal door by lifting upward on the latch handle, then swing the door open. Pull the ash pan out of the firebox, using the lip on the front of the pan. Once the ash pan is removed from the stove, you can flip the carry handle up for convenience.

If removing ashes while a fire is burning, close and latch the ash door while disposing of the ashes.

DO NOT leave the appliance unattended with the ash door open.

DISPOSAL OF ASHES;

Ashes should be placed in a steel container with a tight fitting lid. The container of ashes should be moved outdoors immediately, and placed on a noncombustible floor or the ground, well away from all combustible materials, pending final disposal. If the ashes are disposed of by burial in soil or oth- erwise locally dispersed, they should be retained in the closed container until all cinders have com- pletely cooled. Other waste shall not be placed in this container.

2.Door Glass

•Frequency: As needed / Weekly

•By: User

Whenever the view of the fire is obstructed, or week- ly, clean the glass using a soft cloth dampened with standard household glass cleaner.

CAUTION! DO NOT CLEAN GLASS WHEN HOT. Allow glass to cool before cleaning.

Fly-ash allowed to accumulate on the glass may lead to permanent fogging or "crazing" of the glass.

Inspect the glass and sealing gasket. Replace gasket as needed. Do not operate the stove with a broken glass. Replacement glass, which is ceramic glass, should be obtained only through your Harman dealer.

To replace a broken glass; first be sure to carefully remove the broken glass and any remaining shards or pieces. With the door laying on a flat surface, lay the gasketted glass panel onto the door and be sure it is properly fitted into the channel. Lay the glass retainer clips in place near each corner, and secure them using the 3/8" screws. Be sure to tighten each screw equally so you don't create a pressure point on the glass.

WARNING! Do NOT Use Substitute Material for Glass Replacement.

Caution: never use abrasive materials on the glass.

	Glass Retainers	Glass Retainer
Glass Panel		screws

Glass Gasket

Door Frame

Glass Specifications: 5mm X 419mm X 314mm arched.

Warning: Do not abuse glass by striking or slamming the door closed. This type of breakage is not covered by the product warranty.

28 Dry Seasoned Wood Only! 3-90-08560 Save These Instructions