13
Manual Override
Your lift is equipped with a manual handcrank, to be used in the case of a power failure.
Step 1
Before using the manual handcrank verify that it’s use is required. Check that the emergency stop switch is pulled out. Check that the electrical cord is plugged into the wall. Also check that the buildings circuit breaker has not tripped. Try to run the lift by pushing both the up and down buttons. If the lift still will not run, complete the following steps:
Step 2
Unplug the lift from the wall.
Warning: Do not service or operate the manual handcrank while the lift is connected to electricity.
Step 3
Remove the screws and remove the top cap at the top of the tower.
Step 4
Insert the manual handcrank into the opening on the top of the brake assembly. It may be neccesary to slightly rotate the handcrank until it fully seats down on the hex portion of the brake. Rotate the crank to raise or lower the platform.
Warning: Never operate the lift while the manual override crank is inserted into the lift.
