Using a Phillips/cross head
screwdriver, loosen the screw in
the battery compartment cover
of each TAGGER (screw stays
attached to cover). Remove
cover and battery tray. Insert 6
x 1.5V “AA” or R6 size batteries
(not included) into tray. Alkaline
batteries recommended. Insert
tray, replace cover and
tighten screw.

TO INSERT BATTERIES

IMPORTANT: BATTERY INFORMATION
Please retain this information for future reference.
Batteries should be replaced by an adult.
CAUTION:
1. Always follow the instructions carefully. Use only
batteries specified and be sure to insert item correctly
by matching the + and – polarity markings.
2. Do not mix old batteries and new batteries or standard
(carbon-zinc) with alkaline batteries.
3. Remove exhausted or dead batteries from the product.
4. Remove batteries if product is not to be played with for
a long time.
5. Do not short circuit the supply terminals.
6. Should this product cause, or be affected by, local
electrical interference, move it away from other
electrical equipment. Reset (switching off and back
on again or removing and re-inserting batteries) if
necessary.
7. RECHARGEABLE BATTERIES: Do not mix these with
any other types of batteries. Always remove from the
product before recharging. Recharge batteries under
adult supervision. DO NOT RECHARGE OTHER TYPES
OF BATTERIES.
CAUTION: TO AVOID BATTERY LEAKAGE
1. Be sure to insert the batteries correctly and
always follow the toy and battery manufacturers’
instructions;
2. Do not mix old batteries and new batteries or
alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium) batteries;
3. Always remove weak or dead batteries from
the product.
3