Hatco Hatco 3CS2 manual Model Descriptions, Specifications, All Models, 3CS2 MODELS, FR2 MODELS

MODEL DESCRIPTIONS

ALL MODELS

The Hydro-Heater mounts to the underside

of a holding vessel, leaving the entire vessel area free. Units are shipped ready to install with all gaskets and fittings. Hydro-Heaters include a stainless steel front, powder coated body, a low-water cut-off system and a convenient drain outlet.

3CS2 MODELS

The Hatco 3CS2 model heaters are designed for use with any manual dishwashing operation. The 3CS2 heater maintains sanitizing rinse water of 180ºF (82ºC) by using a special electronic temperature controller and “free flow” technology, assuring a responsive and efficient operation.

FR2 MODELS

The Hatco FR2 model heaters are designed

to be used with a Bain-Marie or Food Rethermalizer to heat or hold foods at temperatures between 140ºF and 190ºF (60° - 88ºC). The desired holding temperature is maintained by a special electronic controller and “free flow” technology, assuring

a responsive and efficient operation.

Figure 1. Hydro-Heater

Figure 2. Hydro-Heater with Auto-Fill

SPECIFICATIONS

PLUG CONFIGURATIONS

WARNING

Units equipped with a power cord and plug should be plugged into an electrical outlet of the correct voltage, size and plug configuration. If the plug and receptacle do not match, contact a qualified electrician to determine the proper voltage and size and install the proper electrical outlet.

Model	208 Volt	240 Volt
FR2-3	NEMA 6-20P	NEMA 6-20P
FR2-4	NEMA 6-30P	NEMA 6-30P

NEMA 6-20P NEMA 6-30P

Figure 3. Plug Configurations

3 Form No. HHM-1103