IMPORTANT SAFETY INSTRUCTIONS
IMPORTANT! Read the following important safety instructions to avoid personal injury or death, and to avoid damage to the equipment or property.
WARNINGS
Hatco 3CS2 and FR2 series units are designed for commercial use only by properly trained personnel! To avoid any injury or damage
to the unit read and follow the instructions contained in this manual. Do not operate this equipment unless you have read and completely understood the contents of this manual.
To avoid any electrical shock hazard, or physical burns turn the power OFF at the fuse disconnect switch/circuit breaker or unplug the unit from the power source and allow to cool completely before performing any maintenance or cleaning.
For proper electrical installation conforming to local electrical codes consult a licensed electrical contractor. Improper electrical connections may cause a serious electrical shock injury or may damage the unit.
For proper plumbing installation conforming to local plumbing codes consult a licensed plumbing contractor.
Units equipped with a power cord and plug should be plugged into an electrical outlet
of the correct voltage, size and plug configuration. If the plug and receptacle do not match, contact a qualified electrician to determine the proper voltage and size and install the proper electrical outlet.
To prevent any injury or damage to the unit do not pull unit by power cord.
To prevent any injury, discontinue use if power cord is frayed or worn.
Units are designed to heat water up to 190ºF (88ºC). DO NOT set temperature controls
to a setting higher than 190ºF (88ºC). Water over 190°F (88°C) is very active and could splash onto operator causing serious burns or injury.
To avoid any injury or damage to the unit use only Authorized Hatco Service Agents to perform any temperature display changes.
If service is required on this unit, contact your Authorized Hatco Service Agent, or contact the Hatco Service Department at
or International fax
WARNINGS
This product has no “user” serviceable parts. To avoid damage to the unit or injury
to personnel, use only Authorized Hatco Service Agents and Genuine Hatco Parts when service is required.
Genuine Hatco Replacement Parts are specified to operate safely in the environments in which they are used. Some aftermarket or generic replacement parts do not have the characteristics that will allow them to operate safely
in Hatco equipment. It is essential to use
Hatco Replacement Parts when repairing Hatco equipment. Failure to use Hatco Replacement Parts may subject operators of the equipment to hazardous electrical voltage, resulting
in electrical shock or burn.
CAUTIONS
Water in the unit and holding vessel is very hot. Wear protective gloves and proper attire when operating to avoid injury.
Do not use extension pipes on the inlet and outlet connections on heater units. Poor performance or unsafe conditions may occur.
Unit is not weatherproof. For safe and proper operation locate the unit indoors where
the ambient air temperature is constant and is a minimum of 70°F (21°C).
1 | Form No. |