Hatco Hatco 3CS2 manual Operation, Remove front control compartment cover

OPERATION

NOTE: If steps 6-9 are interrupted or no changes are made for 15 seconds the controller will go back to its original setting without accepting the change.

NOTE: If unit displays “E1” or “E2” the internal water sensing probe is out of temperature range.

If this occurs contact Hatco Parts and Service Team or an Authorized Service Agent in your area

for assistance.

CHANGING TEMPERATURE DISPLAY FROM FAHRENHEIT (F°) TO CELSIUS (C°)

WARNING

To avoid any injury or damage to the unit use only Authorized Hatco Service Agents to perform any temperature display changes.

A dipswitch panel consisting of four switches is located behind the front graphic overly.

Switch 2 is used to change the temperature display from F° to C°.

1.Turn the power switch to the OFF position at the fuse disconnect switch/circuit breaker and unplug power cord (if equipped) from the power source and allow unit to cool.

2.Remove front control compartment cover.

3.Move dipswitch “2” to the right to change

the display from Fahrenheit (F°) to Celsius (C°).

4.Re-install control compartment cover.

5.Restore power supply and turn power switch to ON.

Form No. HHM-1103 10