013
+CBST: 0,0,1
OK
(On earlier versions of the modem, pre version 2.08 firmware, less information is displayed when this command is issued).
Due to the architecture of the interface circuitry not all of the above commands will necessarily be displayed each time.
Issue 3 Hardware:
This displays additional S and P status:
S displays the status of the interface ie.
S0 - The interface is set for sleep mode.
S1 - The interface is permanently on – default.
(Set using AT+A auto shutdown command).
P displays the modem power consumption.
P0 - The modem is set for low power consumption.
P1 - The modem is set for high power consumption.
(Set using AT+P command).
AT &W
Write configuration to
N.B. – AT+ commands are autosave and therefore execution of this command is not necessary to save these to memory.
A/
+++- TIES (Time Independent Escape Sequence) – When issued to the
modem in an “on line” state this command will place the modem into “on line” command mode.
***- Remote Access command. – When this command is issued from a remotely connected modem it will enable the remote user to interrogate and configure the ASLH306 device.
AT+A RS232 auto shutdown control - toggles on / off
It echoes:
AT+A if
ASL Holdings Limited | 19/09/2005 | 12 |
Draft Copy Version 2c |
|
|