PROBLEM | SOLUTION |
|
| |
4. The walking belt is | a. If the walking belt has shifted to the | a |
| |
left, first remove the key and UNPLUG |
| |||
|
| |||
when walked on | THE POWER CORD. Using the allen |
|
| |
| wrench, turn the left rear roller adjustment |
|
| |
| bolt clockwise, and the right bolt counter- |
|
| |
| clockwise, 1/4 of a turn each. Be careful |
|
| |
| not to overtighten the walking belt. Plug in |
|
| |
| the power cord, insert the key and run the |
|
| |
| treadmill for a few minutes. Repeat until the walking belt is centered. |
| ||
| b. If the walking belt has shifted to the | b |
| |
| right, first remove the key and UNPLUG |
| ||
|
|
| ||
| THE POWER CORD. Using the allen |
|
| |
| wrench, turn the left rear roller adjustment |
|
| |
| bolt counterclockwise, and the right bolt |
|
| |
| clockwise, 1/4 of a turn each. Be careful |
|
| |
| not to overtighten the walking belt. Plug in |
|
| |
| the power cord, insert the key and run the |
|
| |
| treadmill for a few minutes. Repeat until the walking belt is centered. |
| ||
| c. If the walking belt slips when walked | c |
| |
| on, first remove the key and UNPLUG |
| ||
|
|
| ||
| THE POWER CORD. Using the allen |
|
| |
| wrench, turn both rear roller adjustment |
|
| |
| bolts clockwise, 1/4 of a turn. When the |
|
| |
| walking belt is correctly tightened, you |
|
| |
| should be able to lift the edges of the |
|
| |
| walking belt 3 to 4 inches off the walking |
|
| |
| platform. Be careful to keep the walking belt centered. Plug in the power cord, in- | |||
| sert the key and run the treadmill for a few minutes. Repeat until the walking belt | |||
| is properly tightened. |
|
| |
5. The displays of the | a. Remove the key from the console and UN- |
|
| |
console do not func- | PLUG THE POWER CORD. Next, remove | 1/8Ó |
| |
tion properly | the screws from the hood and carefully re- | 28 | ||
2 | ||||
| move the hood. Locate the Reed Switch | |||
|
| |||
| 26 | 85 | ||
| (26) and the Magnet (85) on the left side of | |||
| the Pulley (28). Turn the Pulley until the |
|
| |
| Magnet is aligned with the Reed Switch. | Top |
| |
| Make sure that the gap between the | View |
| |
| Magnet and the Reed Switch is about |
|
| |
| 1/8Ó. If necessary, loosen the Reed Switch |
|
| |
| Screw (2) and move the Reed Switch slightly. Retighten the Screw. | |||
| hood, and run the treadmill for a few minutes to check for a correct speed reading. | |||
23
