1.Hold the Rear Stabilizer (4) against the saddle on the rear of the Frame (1). Make sure that the Rear Stabi- lizer is turned so the square holes are facing away from the Frame. Attach the Rear Stabilizer with two Carriage Bolts (2) and two M10 Nylon Locknuts (55).
2.Slide an M8 Split Washer (85) and an M8 Washer
(89)onto an M8 x 19mm Button Screw (76). Thread the Button Screw into one end of an Incline Axle
(15).Next, apply a small amount of the included grease to the Incline Axle.
Align the indicated tubes on the Incline Frame (7) with the tubes on the Base Frame (1). Make sure that the Incline Frame is turned so the
Slide an M8 Split Washer (85) and an M8 Washer (89) onto another M8 x 19mm Button Screw (76). Thread the Button Screw into the open end of the Incline Axle (15). Do not tighten the Button Screws yet.
3.Slide an M8 Split Washer (85) and an M8 Washer (89) onto an M8 x 19mm Button Screw (76). Next, thread the Button Screw into one end of the Incline Motor Axle (14). With the help of a second person, raise the Incline Frame (7). Insert the Incline Motor Axle through one side of the Incline Frame, through a Plastic Spacer (91), through the end of the motor screw, through another Plastic Spacer (91), and through the other side of the Incline Frame.
Slide an M8 Split Washer (85) and an M8 Washer
(89)onto an M8 x 19mm Button Screw (76). Thread the Button Screw into the open end of the Incline Motor Axle (14).
Tighten the four M8 x 19mm Button Screws (76) used in this step and step 2.
5
1 |
|
|
| 55 |
|
55 |
|
|
1 |
|
|
| 4 |
|
|
| 2 |
2 |
|
|
| ||
| 7 |
|
|
| 85 |
|
| 89 |
|
| 76 |
Grease | 15 | Tubes |
|
| |
89 |
|
|
85 |
|
|
76 | 1 |
|
| Tubes |
|
3 |
|
|
| Motor | 76 |
| Screw | |
| 85 | |
|
| 89 |
| 91 |
|
85 |
|
|
| 14 |
|
89 | 7 |
|
76 |
|
|
