5.Feed all of the slack in the console wire harness down into the Upright (3). Attach the Console (6) to the Upright with four #8 x 3/4Ó Black Screws (44). Be careful to avoid pinching the console wire har- ness.
6.Align the indicated holes in the Incline Frame (2) with the tube on the Base (1). Insert the Incline Axle (75) through the left side of the Incline Frame, through a Plastic Spacer (56), through the tube on the Base, through another Plastic Spacer, and through the right side of the Incline Frame. Using two adjustable wrenches, tighten a 3/8Ó x 1Ó Screw (59), with a Lock Washer (58) and a 3/8Ó Zinc Washer (52), into each end of the Incline Axle.
Tap the two Incline Frame Endcaps (55) into the Incline Frame (2). Remove the backing from the two Bumpers (62). Press the Bumpers onto the underside of the Incline Frame where the Incline Frame touches the front Stabilizer (30).
7.Attach a Pedal (60) to the left Pedal Arm (12) with three #8 x 3/4Ó Black Screws (44).
Attach a Pedal (60) to the right Pedal Arm (not shown).
8.Slide a Pedal Arm Spacer (41), the left Pedal Arm (12), and a Plastic Spacer (56) onto the axle on the left Pulley Arm (34) (these parts fit tightly; it may be helpful to use the rubber mallet). Be careful not to confuse the left Pedal Arm with the right Pedal Arm (not shown); look at the position of the Chrome Extension Tube (63) to identify the left Pedal Arm.
Tap a 3/4Ó Axle Cap (43) onto the axle on the left Pulley Arm (34).
Repeat this step to attach the right Pedal Arm (not shown).
6
5 |
|
| |
6 |
|
| |
Console |
|
| |
Wire |
|
| |
Harness | 3 |
| |
44 |
|
| |
6 |
|
| |
55 |
|
| |
62 | 56 | 59 | |
58 | |||
| |||
62 | 52 |
| |
|
| ||
30 |
|
| |
2 | 1 |
| |
52 |
| ||
|
| ||
58 | Tube |
| |
59 |
| ||
75 | Hole |
| |
|
| ||
7 |
|
| |
| 60 |
| |
44 | 12 |
| |
|
| ||
8 |
|
| |
| 34 |
| |
| 41 |
| |
63 |
|
| |
43 | 12 |
| |
| 56 |
|
