PROGRAMMING THE RADIO THROUGH CPS
2.Make sure the radio is turned ON.
3.Once the radio is connected, open the CPS and select “Read” on the toolbar to get the radio profile. The CPS allows the user to change settings, such as General, Audio, Menu, Channels, Scan List, as well as select frequencies, PL/DPL codes on each channel.
4.After you change the settings, press “Write” on the toolbar to save the settings.
For more information on the Computer Programming Software, please refer to Help menu on the CPS.
Note: (*) CPS Programming Cable (P/N HKKN4025) is an accessory sold separately. Please contact your Motorola Point of Purchase for more information.
Factory Default Settings
Your radio is programmed at the factory to the following settings:
CLP1010 1W UHF 1 CH Radios Default Settings - BRUS
Channel | Frequency | Frequency | Code | Band |
Value | width | |||
# | # | Setting | (Hz) | (kHz) |
|
|
|
|
|
1 | 2 | 464.5500 | 67 | 12.5 |
|
|
|
|
|
CLP1040 1W UHF 4 CH Radios Default Settings - BRUS
Channel | Frequency | Frequency | Code | Band |
Value | width | |||
# | # | Settings | (Hz) | (kHz) |
|
|
|
|
|
1 | 2 | 464.5500 | 67 | 12.5 |
|
|
|
|
|
2 | 8 | 467.9250 | 67 | 12.5 |
|
|
|
|
|
3 | 5 | 467.8500 | 67 | 12.5 |
|
|
|
|
|
4 | 6 | 467.8750 | 67 | 12.5 |
|
|
|
|
|
20
