Turning the Radio On and Off | Motorola CLP series, CLP1040, CLP1010

Turning the Radio On and Off

•To turn the radio ON, press and hold the Power/ Battery button until you hear a short tone and the Smart Status Glow lights up.

•To turn it OFF, press and hold the button until you hear a short tone and the Smart Status Glow (red) indicator blinks once.

Adjusting the Volume

Turn the radio ON and set volume level by pressing volume control (+/- button). A total of 16 volume levels are available.

Installing and Removing the Swivel Belt Clip Holster

1.Slide the bottom of the radio into the holster.

2.Snap the top of the holster into the radio around the accessory connector.

3.To remove the holster, pull either the top or bottom tab(s) and pull the radio from the holster.

Note: When using a corded audio accessory, loop the cord into the recess in the rear of the holster for optimal plug retention.

4.Make a small loop in the cord. Pass the cord through the cord guide, nest the cord in the U-shaped groove. Pull tight to lock the cord in place.

Cord

Guide

U-Shaped

Groove

RADIO OVERVIEW

5

Image 13

Motorola CLP series, CLP1040, CLP1010 manual Turning the Radio On and Off, Adjusting the Volume

Contents

Page Disclaimer Document Copyrights Contents Radio Frequency Code Charts Motorola Limited Warranty Batteries and Chargers Safety InformationProgramming the Radio Through CPS Radio Cloning Computer Software Copyrights Product Safety and RF Exposure Compliance Radio Frequency RF Exposure Safety Standards FCC Licensing Information FCC Licensing Information Introduction Radio Overview Getting Started Install the Battery Connecting an Audio Accessory Installing and Removing the Swivel Belt Clip Holster Adjusting the VolumeTurning the Radio On and Off Talk Range Transmitting and Receiving HOW to Step Operation with Menu Settings Selecting a Channel Default Channel Settings for CPS Monitoring a Channel Sending Call Tone enabled through CPSFor CLP1010 single-channel models For CLP1040 multi-channel models Battery Features Battery and Charger FeaturesAbout the Li-Ion Battery Battery Life Battery Recycling and Disposal Power Supply, Adapter and Drop-in Tray Charger Removing the Lithium-Ion Li-Ion Battery Charging a Standalone Battery Charging the BatteryEstimated Charging Time Charging with the Drop-in Tray Single Unit Charger SUC Charging Status LEDs Charger LED Indicator LED Checking Battery Status Batteries Chargers Safety Information Operational Safety Guidelines Radio Programming Overview Programming the Radio Through CPSDownloading the Customer Programming Software CPS Programming the Radio Factory Default Settings Radio Cloning Cloning Radio SettingsCloning Instructions Radio Cloning What to do if cloning fails Cloning the Radio through a Multi-Unit Charger Programming the RPX through a Single Unit Charger CLP Repeater Capability Working with RPX Programming the RPX through a Multi-Unit Charger CLP Repeater Capability Working with RPX Symptom Try this Troubleshooting Can either reduce obstructions or increase power 13 and Charger LED Indicator Section on Cannot activate VOX VOX feature might be OFF If the portable is submerged in water USE and Care CLP UHF Frequencies Radio Frequency and Code Charts Radiofrequency CCTSS/DPL Interference Eliminator Codes DPL What Does this Warranty Cover? Motorola Limited Warranty for the United StatesProducts and Accessories Exclusions HOW to Obtain Warranty Service or Other INFORMATION? What WE will do to Correct Warranty ProblemsSoftware WHO is COVERED? Retain Your Original Proof of Purchase Software Copyright Notice Export LAW Assurances Patent Notice Carry Accessories AccessoriesBatteries Chargers Accessories Page 68012000044