Motorola CLP series, CLP1010, CLP1040

TROUBLESHOOTING

Heavy static or interference Radios are too close, they must be at least five feet apart.

Radios are too far apart or obstacles are interfering with

transmission.

Low batteries Recharge or replace Li-Ion battery.

Extreme operating temperatures affect battery life.

Refer to “About the Li-Ion Battery” Section on page 10.

Drop-in Charger LED light does

not blink

Check radio/battery is properly inserted and check battery/

charger contacts to ensure they are clean and the charging pin

is inserted correctly. Refer to “Charging the Battery” Section on

page 13 and “Charger LED Indicator” Section on page 15.

Symptom Try t his

Contents

Main Page CONTENTS CONTENTS CONTENTS COMPUTER SOFTWARE COPYRIGHTS COMPUTER SOFTWARE COPYRIGHTS RF SAFETY STANDARDS RADIO FREQUENCY (RF) EXPOSURE SAFETY STANDARDS Product Safety and RF Exposure Compliance ATTENTION! FCC LICENSING INFORMATION FCC LICENSING INFORMATION INTERFERENCE INFORMATION FCC LICENSING INFORMATION INTRODUCTION INTRODUCTION PACKAGE CONTENTS RADIO OVERVIEW RADIO CONTROLS GETTING STARTED INSTALL THE BATTERY Connecting an Audio Accessory Connect the wired audio accessory or pair with a wireless accessory (select models only). Turning the Radio On and Off Adjusting the Volume Installing and Removing the Swivel Belt Clip Holster TRANSMITTING AND RECEIVING Table 1: Talk Range OPERATION WITH MENU SETTINGS HOW TO... STEP 1 STEP 2 Selecting a Channel For CLP1040 multi-channel models only: Table 2: Default Channel Settings for CPS Monitoring a Channel For CLP1010 single-channel models For CLP1040 multi-channel models Scanning (*) Sending Call Tone (enabled through CPS) BATTERY AND CHARGER FEATURES BATTERY FEATURES About the Li-Ion Battery Battery Life Based on 5% transmit, 5% receive, 90% standby (standard duty cycle): Battery Recycling and Disposal Page Charging the Battery Estimated Charging Time Charging a Standalone Battery Charging with the Drop-in Tray Single Unit Charger (SUC) Charging with the Drop-In Tray Multi-Unit Charger (Optional Accessory) 5. Insert the radio (with battery installed) into the charging pocket. Charging Status LEDs Checking Battery Status Battery Status Level LED Status Color BATTERIES AND CHARGERS SAFETY INFORMATION BATTERIES AND CHARGERS SAFETY INFORMATION BATTERIES AND CHARGERS SAFETY INFORMATION OPERATIONAL SAFETY GUIDELINES PROGRAMMING THE RADIO THROUGH CPS PROGRAMMING THE RADIO THROUGH CPS RADIO PROGRAMMING OVERVIEW Downloading the (Customer Programming Software) CPS Programming the Radio PROGRAMMING THE RADIO THROUGH CPS Factory Default Settings RADIO CLONING CLONING RADIO SETTINGS Page What to do if cloning fails Cloning Radios using the (optional accessory) CLP REPEATER CAPABILITY: WORKING WITH RPX CLP REPEATER CAPABILITY: WORKING WITH RPX CLP REPEATER CAPABILITY INSTRUCTIONS Programming the RPX through a Single Unit Charger CLP REPEATER CAPABILITY: WORKING WITH RPX Programming the RPX through a Multi-Unit Charger TROUBLESHOOTING Page Page Page USE AND CARE USE AND CARE If the portable is submerged in water... RADIO FREQUENCY AND CODE CHARTS Table 3: CLP UHF Frequencies RADIO FREQUENCY AND Table 4: CCTSS/DPL Interference Eliminator Codes Page MOTOROLA LIMITED WARRANTY FOR THE UNITED STATES What Does this Warranty Cover? Products and Accessories Exclusions Software Exclusions WHO IS COVERED? WHAT WE WILL DO TO CORRECT WARRANTY PROBLEMS HOW TO OBTAIN WARRANTY SERVICE OR OTHER INFORMATION? SOFTWARE COPYRIGHT NOTICE PATENT NOTICE EXPORT LAW ASSURANCES ACCESSORIES ACCESSORIES Page Page M *68012000044* 68012000044-B