What to do if cloning fails | Note: | This cloning cable is designed to operate |
The radio will emit an audible “bonk” indicating |
| only with compatible Motorola |
| Single Unit Charger. When ordering the | |
that the cloning process has failed. In the event |
| |
| cloning cable, please refer to CLP Series | |
that cloning fails, try performing each of the |
| |
| Cloning Cable Kit P/N HKKN4026. For | |
following before trying to start the cloning |
| details about accessories, refer to |
process again. |
| "Accessories" Section on page 41. |
|
|
1.Make sure that the radio batteries on both radios are fully charged.
2.Verify the cloning cable connection on both Single Unit Chargers.
3.Make sure that the battery is engaged properly on to the radio.
4.Make sure that there is no debris in the charging tray or on the radio contacts.
5.Verify that the source radio is in cloning mode.
6.Make sure that the radio to be cloned is turned ON.
7.Make sure that radios are both from the same type (same frequency band, same region and same transmission power).
RADIO CLONING
23
