Motorola CLP1010, CLP1040, CLP series manual Charging Status LEDs, Charger LED Indicator

Note: If the radio is ON while charging, it will take longer to fully charge.

5.Insert the radio (with battery installed) into the charging pocket.

Note: The radio will fit in the charger with the holster attached when placed face down in the tray. The battery can be charged by itself using the slot on the flat surface of the charging pocket.

Charging Status LEDs

On the drop-in charger, the radio charging pocket has an LED Charger.

On the MUC, each of the 6 charging pockets has an LED. The LEDs are grouped into pairs to show which charging pockets are paired. The LED is red when the battery is charging. It turns to green once the battery is fully charged.

Note: This Multi Unit Charger allows you to clone up to 2 radios (2 Source radios and 2 Target radios). For more details, refer to “Radio Cloning” Section on page 21.

•For part number details, refer to the“Accessories” Section on page 41.

Charger LED Indicator

Status	LED Status	Comments
Charging	Steady	The charger is
	Red	currently charging.
	Indication
Charge	Steady	Battery is fully
Complete	Green	charged.
	Indication
Battery	Blinking	Battery was faulty
Fault (*)	Red	when inserted.

Note: The LED is red when the battery is charging. It turns to green once the battery is fully charged.

Note: (*) Re-seating the battery pack will likely correct this issue.

BATTERY AND CHARGER FEATURES

15