Healthrider s300i, HRTL05910 manual Problem Solution

PROBLEM	SOLUTION
4. The walking belt is	a. Remove the key and UNPLUG THE
			a
off-center or slips	POWER CORD. If the walking belt has
when walked on	shifted to the left, use the allen wrench to
	turn the left rear roller bolt clockwise 1/2 of
	a turn. Be careful not to overtighten the
	walking belt. If the walking belt has
	shifted to the right, turn the left rear roller
	bolt counterclockwise 1/2 of a turn. Plug in
	the power cord, insert the key and run the
	treadmill for a few minutes. Repeat until the walking belt is centered.
	b. If the walking belt slips when walked on,
			b
	first remove the key and UNPLUG THE
	POWER CORD. Using the allen wrench,
	turn both rear roller bolts clockwise 1/4 of a
	turn. When the walking belt is correctly
	tightened, you should be able to lift each
	side of the walking belt 3 to 4 inches off the
	walking platform. Be careful to keep the
	walking belt centered. Plug in the power
	cord, insert the key and carefully walk on the treadmill for a few minutes. Repeat
	until the walking belt is properly tightened.
5. The displays of the	a. Remove the key from the console and UN-
		a
console do not func-	PLUG THE POWER CORD. Next, remove
						1/8”
tion properly	the screws from the hood and carefully re-
								11
	move the hood. Locate the Reed Switch					20
	(26) and the Magnet (85) on the left side of						26		85
	the Pulley (11). Turn the Pulley until the
	Magnet is aligned with the Reed Switch.				Top
	Make sure that the gap between the			View
	Magnet and the Reed Switch is about
	1/8”. If necessary, loosen the Reed Switch
	Screw (20) and move the Reed Switch slightly. Retighten the Screw. Re-attach the
	hood, and run the treadmill for a few minutes to check for a correct speed reading.

23