ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench
and a phillips screwdriver 
, an adjustable wrench 
, and wire cutters 
.
Note: The underside of the treadmill walking belt is coated with
1.With the help of a second person, carefully raise the Uprights (110) to the position shown.
Refer to the inset drawing. Insert one of the Extension Legs (88) into the treadmill as shown. Make sure that the Extension Leg is turned so the Thick Base Pad (90) is on the bottom. Note: It may be helpful to tip the Uprights (110) forward as you insert the Extension Leg.
Insert the other Extension Leg (not shown) in the same way.
2.With the help of a second person, carefully tip the Uprights (110) down as shown. Make sure that the
Extension Legs (88) remain in the Uprights.
Attach each Extension Leg (88) with two Base Screws (86) and a Base Pad (75) as shown.
With the help of a second person, carefully tip the Uprights (110) back to the vertical position.
Note: One replacement Thick Base Pad (90) may be in- cluded. If a Thick Base Pad needs to be replaced, use the replacement Thick Base Pad.
3.It may be helpful to set the Handrails (89) on the Uprights (110) and loosely thread a Handrail Bolt (111) into the left Upright and the left Handrail as shown. Tip the Handrails, if necessary, to thread in the Bolt. Have another person support the Handrails as you complete the remaining steps.
1 |
|
|
| 110 |
|
|
| 110 |
|
| 88 |
|
| 90 |
2 |
|
|
| 90 |
|
| 90 |
|
|
| 75 |
| 110 |
|
110 | 88 | 86 |
75 | 86 | 90 |
|
| |
90 | 88 |
|
|
| |
3 |
|
|
| 89 |
|
110 |
|
|
111 |
|
|
