4.Pull the Upright Wire Harness (101) and the TV Cable (104) up through the Right Handrail Spacer (107) (refer to drawing A to distinguish the Right Handrail Spacer from the Left Handrail Spacer [106]). Place the Right Handrail Spacer on the right Upright (110).
Connect the Upright Wire Harness (101) and the TV Cable (104) to the two wires extending from the Console Base (76). Insert the connectors, the Upright Wire Harness, and the TV Cable into the hole in the Console Base (refer to inset drawing B).
Set the Handrail (89) on the Right Handrail Spacer (107), being careful not to pinch the Upright Wire Harness (101) and the TV Cable (104).
5.Insert two Handrail Bolts (111) with Handrail Washers (112) into the right Upright (110) and the Right Handrail Spacer (107). Lift the right Handrail (89) slightly and align the Bolts with the holes in the Handrail. Loosely thread the Bolts into the Handrail. Do not tighten the Bolts yet.
Refer to step 3. Remove the Handrail Bolt (111) from the left Upright (110) and the left Handrail (89).
Place the Left Handrail Spacer (106, not shown) on the left Upright (110, not shown). Attach the left Handrail (89) as described above. Tighten all four Handrail Bolts (111).
6.Attach the Latch Assembly (109) to the left Upright (110) with two Latch Screws (86).
7.Note the location of the 75 ohm antenna terminal on the treadmill. For the television to operate properly, an antenna, a CATV cable, or a VCR must be connected to the 75 ohm antenna terminal.
If you are using an antenna, it must be properly con- nected and adjusted for optimal reception. Refer to AN- TENNA CONNECTIONS on page 22 to properly connect an antenna. If you are using a CATV cable, refer to CATV CABLE CONNECTION on page 22 to properly con- nect the cable. If you are using a VCR, refer to HOW TO CONNECT A VCR on page 24 to properly connect the VCR. The VCR must be turned on, a videocassette must be properly inserted, and the VCR must be play- ing. Refer to your VCR user’s manual for operating in- structions.
4 | 76 | A |
|
| 106 | ||
|
| ||
| 89 |
| |
| 107 | 110 | 107 |
|
| ||
| 101 | B | 101 |
|
| ||
|
| 104 |
|
| 104 |
|
|
|
|
| 76 |
5 |
| 89 | |
|
| ||
|
|
| 107 |
|
|
| 110 |
|
| 112 |
|
|
|
| 111 |
6 |
|
|
|
| 86 |
| 110 |
|
|
| |
| 109 |
|
|
7 | 75 Ohm Antenna | ||
| |||
| Terminal |
| |
8 . Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 27). To protect the floor or carpet from damage, place a mat under the treadmill.
8
