R
Cumberland Gap Wood Stove
MAINTENANCE (Cont'd)
GLASS REPLACEMENT
1. Ensure that the fire is out and the appliance is cool to the touch.
2.Protect a table or counter top with padding or towels.
3.Remove door with broken glass from the appliance by lifting door up and off of the hinges.
4.Lay door face down on a table or counter making sure handle and fiber handle hang over the edge of the table top so door lays flat, on a soft surface.
5.Remove the screws from each glass retainer. If screws are hard to remove, soak with penetrating oil first.
6.Remove the glass.
7.Use only 5mm ceramic glass, Part
8.Position the glass with edges evenly overlapping the opening in the front door.
9.Replace the glass retainers. Be careful not to cross thread the screws.
10.Tighten each retainer just a few turns until each is secured. Then continue to tighten each retainer alternately, a few turns at a time, until the glass panel is tightened snugly.
11.Replace the door on the appliance.
CARE AND CLEANING OF PLATED SURFACES
IMPORTANT: You must clean all the fingerprints and oils from the plated surfaces before firing the stove for the first time. Use warm soapy water and a soft rag, glass cleaner and a paper towel, or vinegar and a paper towel to remove the oils. DO NOT use abrasive cleaners! If not cleaned properly prior to lighting the first fire, the oils can cause permanent stains. The plating will be cured upon firing of the stove and oils will no longer affect the finish. Subsequently, little maintenance is then required. Wipe clean as needed with a soft towel.
DOOR GASKET
Periodically check the door gasket for proper seal. As the gasket compresses or “seats” during use, it may become necessary to replace the gasket material as wear or damage to the gasket material can cause air leakage into the firebox resulting in overfiring and loss of efficiency.
DOOR HANDLE ASSEMBLIES
All Doors
•Install washer on door handle shaft.
•Slide door handle through door. Right & side door:
•Install additional spacing washer(s) as needed.
•Install bushing, door latch and locknut.
Caution! Do not overtighten locknut. Door handle needs to move smoothly.
Left door:
•Install locking pin and locknut. Securely tighten locknut. This handle assembly is stationary.
All doors
•Insert fiber door handle with threads going into door handle shaft. Turn handle clockwise until tight.
| FRONT DOOR HANDLE ASSEMBLIES |
| SIDE DOOR HANDLE | ||
|
|
|
|
| ASSEMBLY |
|
| Spacing Washers |
|
| |
| Lock Nut | Door |
|
|
|
|
|
|
|
| |
| Locking Pin | Latch | Bushing |
|
|
|
| Lock |
|
|
|
|
| Nut | Washer | Handle | Fiber Handle |
|
|
| |||
|
|
|
| ||
| Washer |
|
|
| WARNING! DO NOT OPERATE |
Fiber | Door |
|
|
| THE WOODSTOVE IF THE DOOR |
Handle |
|
|
| ||
Handle |
|
|
| GLASS IS BROKEN OR MISSING. | |
Shaft |
|
|
| ||
|
|
|
|
| DANGEROUS OVERFIRING CAN |
| LEFT DOOR |
| RIGHT DOOR | OCCUR WHICH CAN DAMAGE THE | |
|
| APPLIANCE OR IGNITE CREO- | |||
Left Handle Assembly is Stationary |
|
|
| ||
|
|
| SOTE IN THE CHIMNEY, POSSIBLY | ||
|
|
|
|
| CAUSING A HOUSE FIRE. |
Page 26 |
|
|
| September 1, 2008 | |
