R
Cumberland Gap Wood Stove
|
| |
1. |
| Place the unit in a location near the final installa- |
|
| tion area and follow the procedures below. |
2. |
| Open the stove and remove all the parts and |
|
| articles packed inside. Inspect all the parts and |
|
| cast iron body for shipping damage. Contact |
|
| your dealer if any irregularities are noticed. |
3. |
| All safety warning have been read and fol- |
|
| lowed. |
4. |
| This Owner's Manual has been read. |
5. |
| Floor protection requirements have been met. |
6. |
| Chimney connector is properly installed. |
7. |
| The proper clearances from the stove and chim- |
|
| ney to combustibles materials have been met. |
8. |
| The masonry chimney is inspected by a pro- |
|
| fessional and is clean, or the |
|
| metal chimney is installed according to the |
|
| manufactuer'rs instrucitons and clearances. |
9. |
| The chimney meets the required minimum |
|
| height. |
10. |
| All labels have been removed from the glass |
|
| doors. |
11. |
| Plated surfaces have been wiped clean. |
CAUTION!
DO NOT TILT THE UNIT ON THE CAST IRON LEGS. Lift the unit upright and place it into position on the floor protector.
TABLE OF CONTENTS |
|
SERIAL NUMBER LABEL & LOCATION | 2 |
3 | |
LISTINGS & SAFETY NOTICES | 4 |
INSTALLATIONS MATERIAL NEEDED FOR SAFETY 4 | |
VENTING SYSTEM | 4 |
DIMENSIONS & VENT SPECIFICATIONS | 5 |
CLEARANCE TO COMBUSTIBLES | 6 |
FLOOR PROTECTION | |
ALTERNATE FLOOR PROTECTION | 8 |
INSTALLATION |
|
Locating your stove | 9 |
Side door locking mechanism | 9 |
Leg leveling system | 9 |
Reversible flue collar | 10 |
Chimney height requirements, | 11 |
Chimney connector | 11 |
Masonry chimney | 12 |
Solid pack chimney with Metal supports |
|
as a thimble | |
Masonry fireplace | 14 |
Metal prefabricated chimney | 15 |
Mobile home installation | 16 |
Outside air kit installation | 17 |
Optional Blower installation | 17 |
Baffle Diverter Installation | |
OPERATION |
|
20 | |
Burning process | 20 |
Air controls | 21 |
Heat output setting | 22 |
Building a fire | 22 |
Correct baffle & blanket placement | 23 |
Opacity | 24 |
Burn rates | 24 |
Wood selection and storage | 24 |
Blower operating instructions | 24 |
MAINTENANCE |
|
Creosote formation & removal | 25 |
Chimney cleaning | 25 |
Ash removal | 25 |
Glass care & replacement | |
Care & cleaning of plated surfaces | 26 |
Door gasket & door handle assembly | 26 |
Brick replacement | 27 |
Baffle removal & installation | 27 |
PARTS DIAGRAM | 28 |
SERVICE PARTS & ACCESSORIES | |
SERVICE & MAINTENANCE LOG | 31 |
WARRANTY POLICY | 32 |
CONTACT INFORMATION | 36 |
September 1, 2008 | Page 3 |
