Hearth and Home Technologies Cyclone-Cust owner manual B. Connecting to the Appliance

B. Connecting to the Appliance

WARNING

Wire 110V to terminal block.

Do NOT wire 110V to valve.

Do NOT wire 110V to wall switch.

•Incorrect wiring will damage this valve.

•Incorrect wiring will override HSI safety lockout and may cause explosion.

•This appliance comes factory wired with a remote control for operation. The remote can be removed and the appliance can be wired to run off of a standard wall switch. Refer to the wiring diagram for more information.

•Keep wire lengths short as possible by removing any excess wire length.

•Low voltage and 110 VAC voltage cannot be shared within the same wall box.

C. Hot Surface Ignition Wiring

This appliance requires a 110 VAC supply to the appli- ance terminal block for operation. A wiring diagram is shown in Figure 10.9. This appliance is equipped with a 24V valve.

Optional Accessories Requirements

Wiring for optional accessories should be done now to avoid reconstruction.

CAUTION

Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing.

WARNING

Shock hazard.

•Replace damaged wire with type 105º C rated wire.

•Wire must have high temperature insulation.

				GROUND	FAN MOTOR
				(L1) 120-BLACK
				(N) NEUTRAL-WHITE
REMOTE
		8
		24 VOLT TRANS	3
	2				2
		1	5
					SENSOR
			9
7	6
		CONTROL MODULE
				4
	HOT SURFACE IGNITOR	1			3
	(HSI)
	ITEM	PART DESCRIPTION		COLOR(S)
	1	(M)L1 - (M)F1 - (T) 23 - -120V		Black
	2	(FT) BTM-IGN-(T)1- +120V		Black/White
	3	(V)1 & (V)3 - GND & (T)4		Blue/Green
	4	(V)2 & (V)4 - (M)MV1		Red
	5	(M) F2 - (FT) TOP		White
	6	(M)S1-IGN		White
	7	FEMALE RECEPTACLE PLUG		Black/White/Green
	8	REMOTE WITH PIGTAIL - (M)W OPTIONAL		Red
Figure 10.9 Wiring diagram	9	(M)R - (M)W - (M)P.SW - REM/WS		Red
	Heat & Glo • Cyclone-Cust • 2061-900 Rev. L • 10/08				29