B. Maintenance Tasks
Inspect |
| Maintenance Tasks | |
|
|
| |
| 1. | Inspect for scratches, dents or other damage and repair as necessary. | |
Doors, Surrounds and |
|
| |
2. | Verify no obstructions to airflow through the louvers. | ||
Fronts |
|
| |
| 3. | Verify maintenance of proper clearance to combustible household objects. | |
|
|
| |
| 1. | Inspect gasket seal and its condition. | |
|
|
| |
Gasket Seal, Glass | 2. | Inspect glass cylinder for scratches and nicks that can lead to breakage when exposed to heat. | |
|
| ||
Assembly and Glass | 3. Confirm there is no damage to glass or glass frame. Replace as necessary. | ||
| |||
|
|
| |
| 4. | Clean glass. Replace glass assembly if severely coated with silicate deposits that cannot be removed. | |
|
|
| |
| 1. | Vacuum and wipe out dust, cobwebs, debris or pet hair. Use caution when cleaning these areas. Screw | |
|
| tips that have penetrated the sheet metal are sharp and should be avoided. | |
Valve Compartment |
|
| |
|
| ||
and Firebox Top | 2. | Remove any foreign objects. | |
|
|
| |
| 3. | Verify unobstructed air circulation. | |
|
|
| |
| 1. | Verify burner is properly secured and aligned with pilot or igniter. | |
|
|
| |
| 2. | Clean off burner top, inspect for plugged ports, corrosion or deterioration. Replace burner if necessary. | |
|
|
| |
| 3. | Check for smooth lighting and ignition carryover to all ports. Verify there is no ignition delay. | |
Burner Ignition and |
|
| |
4. | Inspect for lifting or other flame problems. | ||
Operation | |||
|
| ||
| 5. | Verify air shutter is clear of dust and debris. | |
|
|
| |
| 6. | Inspect orifice for soot, dirt or corrosion. | |
|
|
| |
| 7. | Verify manifold and inlet pressures. Adjust regulator as required. | |
|
| ||
| 1. Inspect venting for blockage or obstruction such as bird nests, leaves, etc. | ||
|
|
| |
| 2. | Confirm that termination cap remains clear and unobstructed by plants, etc. | |
|
|
| |
Venting | 3. | Verify that termination cap clearance to subsequent construction (building additions, decks, fences or | |
| sheds) has been maintained. | ||
|
|
4.Inspect for corrosion or separation.
5.Verify weather stripping, sealing and flashing remains intact.
Remote controls 1. Verify operation of remote.
Heat & Glo • | 37 |