B. Lighting the Fireplace

Electronic Ignition

FOR YOUR SAFETY

READ BEFORE LIGHTING

WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life.

LIGHTING INSTRUCTIONS

1. This fireplace is equipped with an

ignition device which automatically

lights the burner. Do not try to light

A. This fireplace is equipped with an electronic pilot ignition device which automatically lights the burner. Do not try to light the burner by hand.

B. BEFORE LIGHTING, smell all

around the fireplace area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

• Do not try to light any appliance.

Do not touch any electric switch; do not use any phone in your building.

Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

If you cannot reach your gas sup- plier, call the fire department.

C. Do not use this fireplace if any part has been under water. Immediately call a qualified service technician to inspect the fireplace and to replace any part of the control system and any gas control which has been under water.

the burner by hand.

2. Wait five (5) minutes to clear out any

gas. Then smell for gas, including

near the floor. If you smell gas, STOP!

Follow “B” in the Safety Information

located on the left side of this label. If

you don’t smell gas, go to next step.

WARNING: CAUTION:

3. To light the burner, simultaneously

press the star

and up

arrow

DO NOT CONNECT 240 VAC TO THE CONTROL VALVE.

Improper installation, adjustment, alteration, service or maintenance can cause injury or property dam- age. Refer to the owner’s information manual provided with this fireplace.

This fireplace needs fresh air for safe operation and must be installed so there are provisions for adequate combustion and ventilation air.

If not installed, operated, and main- tained in accordance with the man- ufacturer’s instructions, this product could expose you to substances in fuel or fuel combustion.

Keep burner and control compart- ment clean. See installation and operating instructions accompanying fireplace.

Hot while in operation. Do not touch. Keep children, clothing, furniture, gasoline and other liquids having flammable vapors away.

Do not operate the fireplace with panel(s) removed, cracked or bro- ken. Replacement of the panel (s) should be done by a licensed or qualified service person.

NOT FOR USE

WITH SOLID FUEL

For use with natural, propane and butane gases.

buttons on the remote control until a

short acoustic signal confirms the start

sequence has begun.

4. If the fireplace will not operate, check

the batteries then follow the instruc-

tions “To Turn Off Gas to Fireplace”

and call your service technician or gas

supplier.

TO TURN OFF GAS TO FIREPLACE

1.Push the ‘OFF’ button on remote.

2.Remove batteries from receiver.

18

Heat & Glo Lifestyle Collection • Dakota 42-CE4036-915 Rev I • 1/07

Page 18
Image 18
Hearth and Home Technologies Dakota 42-CE manual For Your Safety Read Before Lighting Lighting Instructions