Heat & Glo • SL-350TRS-CE-D • 2033-900 Rev. N • 10/07
22
Figure 21. Remove the insulation from the outer flue
pipe.
Rear Flue
2 SCREWS
Figure 22. To attach the first section of vent pipe, make
sure to use the fiberglass gasket to seal between the
first vent component and the outer fireplace wrap. Use
2 self tapping screws to secure the gasket to the outer
wrap.
Note: Once the flue cap has been removed, it cannot
be reattached.
Figure 23. Remove the insulation from the outer flue
pipe.
Figure 24. Cut the metal retaining band and fold the
sides out.
Figure 25. Fold the center parts of the retaining band
out and us to remove the flue cap.
Figure 26. Discard the flue cap, remove and discard
the insulation basket. Note: Once the flue cap has
been removed it CANNOT be reattached.
Figure 27. Attach the first flue section (it will snap into
place). Slide the insulation gasket onto the flue sec-
tion, up against the appliance and over the tabs. Use
two self-tapping screws to secure gasket to outer wrap.