Hearth and Home Technologies SL-350TRS-CE-D Approvals and Regulations

Heat & Glo • SL-350TRS-CE-D • 2033-900 Rev. N • 10/07 7

Appliance Certification

The Heat & Glo fireplace models discussed in this

Installers Guide have been tested to certification

standards and listed by the applicable laboratories.

CERTIFICATION

MODEL LABORATORY TYPE STANDARD

SL-350TRS-CE-D

Advantica Gas Fireplace 90/396/EEC

Installation Regulations

Before installation check that local distribution conditions, nature of gas and

pressure, and adjustment of the appliance are compatible.

This appliance must be installed with the rules in force, and used only in a

sufficiently ventilated space. Consult instructions before installation and use of

this appliance.

ApprovalsandRegulations

Contents

Main Model: SL-350TRS-CE-D Installers Guide Page Table of Contents Page (NG, LP) Service Parts List SL-350TRS-CE-D Service Parts SL-350TRS-CE-D Appliance Certification Installation Regulations Approvals and Regulations Introducing the Heat & Glo Gas Fireplaces Pre-installation Preparation 2 Getting Started Heat & Glo SL-350TRS-CE-D 2033-900 Rev. N 10/07 Figure 1. Diagram of the SL-350TRS-CE-D Installing the Step 1 Locating the Fireplace Clearance Requirements Step 2 Framing the CAUTION A. Flue System Approvals Step 3 Installing the Flue System NOTE: PIPES OVERLAP 32mm AT EACH JOINT. FIGURE 6. DVP-Series Balanced Flue Component Specifications (127mm inner pipe / 203mm outer pipe) Page Page Page VH + H Use DVP-Series components only. Figure 12. Flue with Two 90 Elbows H FLUE WITH TWO (2) 90 ELBOWS Figure 13. Flue with Two 90 Elbows Use SL D-Series components only. V H V Figure 14. Flue with three 90 elbows USE DVP-SERIES COMPONENTS ONLY. Heat & Glo SL-350TRS-CE-D 2033-900 Rev. N 10/07 Figure 15. Flue with three 90 elbows USE SL D-SERIES COMPONENTS ONLY. Appliance Preparation Top Flue CAUTION Rear Flue B. Installing Flue Components 3. Install Support Brackets 4. Install Firestops Page C. Flue Termination Page Page NOTE V = VENT TERMINAL X Step 5 The Gas Control System Step 4 Positioning, Leveling, and Securing the Fireplace Step 6 The Gas Supply Line For Standing Pilot Ignition Wiring Appliance Requirements Step 8 Wiring the Step 7 Gas Pressure Requirements ______________________________________________________________ CAUTION Step 9 Finishing Step 10 Installing Trim, Logs, and Ember Material CAUTION Page Page LOG #6 (SRV540-704): Step 11 Before Lighting the Fireplace After the Installation Step 12 Lighting the Fireplace Maintaining and Servicing Your Fireplace Maintenance IMPORTANT YOUR FIREPLACE. Page Standing Pilot Troubleshooting Trouble- shooting