Heartland Bakeware 9200/7200 Installation of Ducting, Installation through an outside wall, Model

Installation of Ducting

Installation through an outside wall

Remove air deflector (used for ventless operation only). Cut appropriate-sized hole through the wall directly behind the range hood outlet (see Figure 5, page 9), making sure no wall studs are cut. Push range into position. From outside of the house, measure distance from the siding to the range outlet. Cut duct pipe that length, plus 1" (25mm) for overlap into outlet. Attach vent hood to pipe. Caulk the back of vent hood and around pipe where it goes through wall and into range hood outlet so caulking seals against outside siding.

Complete installation by following directions under Ventless Installation.

Installation through an attic to an outside wall

If the vent elbows are embed- ded in the wall, the range may be positioned as shown in Page 9, Figure 5. Continue the ducting through the ceiling into the attic. Terminate duct either on an outside wall just below the sofit using a vent hood or through the roof with a roof cap. Seal with caulking around and under cap or hood.

Complete your installation by following directions under Ventless Installation.

						RangeHoodOutlet
	14”						3-1/4” x 10”			20”
							8 cm x 25 cm			51 cm
36 cm
		29-1/2”					4-3/4”
						56”	12 cm
		75 cm
						142 cm
									Gas Inlet-1/2” NPT
											66-1/4”
									Power		169 cm
									Cord
						36-1/8”
						92 cm			Exhaust
									Hood
							30”
									(female)
							76 cm		Receptacle
			28”							39-3/4”
			72 cm						47-1/2”	101 cm
								122 cm
						Figure 6
					Model 7200
			RangeHoodOutlet
		13-3/4”		3-1/4” x 10”
				8 cm x 25 cm
		35 cm
							14”
							36 cm
56”									29-1/2”
142 cm
			Gas Inlet-1/2” NPT						75 cm
					66-1/4”
			Power		168 cm
			Cord
			ExhaustHood
36-1/8”					62-3/8”
92 cm			Receptacle(female)		159 cm
	34”
	86 cm
3-3/4”			29-3/4”						28”
10 cm									72 cm
			76 cm			Figure 7

Model 9200

9