D. Vent Diagrams
Note: The 6000 series fireplaces can adapt to SLP series vent pipe, if desired.
When venting off the top of the unit, use a
After the 48 inch vertical section, the venting table rules must be followed. The first 48 inch vertical section is NOT counted as part of the vertical components in the table. It is still counted as part of the overall maximum run. All venting table rules for the vent run must still be followed.
Example: DVP pipe 3 ft. min. vertical = 11 ft. max. horizontal SLP pipe 7 ft. min. vertical = 11 ft. max. horizontal
1.Top Vent - Horizontal Termination One Elbow
Figure 5.3
WARNING
Fire Risk. Explosion Risk.
Do NOT pack insulation or other combustibles between ceiling firestops.
•ALWAYS maintain specified clearances around venting and firestop systems.
•Install wall shield and ceiling firestops as speci- fied.
Failure to keep insulation or other material away from vent pipe may cause fire.
WARNING
Fire Risk.
•When using
V1 Minimum | H1 Maximum | |||
Elbow only | 2 ft | 610 mm | ||
1 ft. |
| 305 mm | 3 ft. | 914 mm |
2 ft. |
| 610 mm | 6 ft. | 1.8 m |
3 ft. |
| 914 mm | 11 ft. | 3.4 m |
4 ft. |
| 1.2 m | 20 ft. | 6.1 m |
V1 | + H1 = 40 ft. (12.2 m) Maximum | |||
| H1 = 20 ft. (6.1 m) Maximum | |||
Note: For corner installations: A 6 inch (152
mm)section of straight pipe may need to be attached to the appliance before a 90o elbow, to allow the vent pipe to clear the top standoffs.
Two Elbows
Note: For corner installations: A 6 inch (152 mm) section of straight pipe may need to be attached to the appliance before a 90o elbow, to allow the vent pipe to clear the top standoffs.
V1 Minimum | H1 + H2 Maximum | ||
Elbow only | 1 ft. | 305 mm | |
6 in. | 152 mm | 2 ft. | 610 mm |
1 ft. | 305 mm | 2 ft. | 610 mm |
2 ft. | 610 mm | 4 ft. | 1.2 m |
3 ft. | 914 mm | 9 ft. | 2.7 m |
4 ft. | 1.2 m | 18 ft. | 5.5 m |
5 ft. | 1.5 m | 20 ft. | 6.1 m |
V1 + H1 + H2 = 40 ft. (12.2 m) Maximum
H1 + H2 = 20 ft. (6.1 m) Maximum
Figure 5.4
Heat & Glo • 6000G, | 13 |
