Heat & Glo LifeStyle 6000G-LP, 6000G-IPILP owner manual Two Elbows, Reinstall the Exhaust Shield

3.Match the amount of vertical you have in the sys- tem with the chart to find the appropriate position to set the Flue Restrictor (see Figure 5.9 ).

Vertical	TOP VENT		REAR VENT
	NG	LP	NG	LP
4 ft.	1-1	No	No	No
		Restrictor	Restrictor	Restrictor
8 ft.	2-2	1-2	1-1	No
				Restrictor
15 ft.	3-3	3-2	2-2	1-2
20 ft.	3-4	3-3	3-3	2-3
25 ft.	3-4	3-3	3-3	2-3
30 ft.	4-4	3-4	3-4	3-3
35 ft.	4-4	3-4	3-4	3-3
40 ft.	5-4	4-4	4-4	3-4

Figure 5.9

Note: If the DVP-2SL adapter and SLP pipe is used, you MUST subtract one number from the table above.

Example: Top vent 40 ft vertical with DVP pipe = 5-4 Top vent 40 ft vertical with SLP pipe = 4-3

Two Elbows

4. Center the Flue Restrictor on vent and secure in place by using two self-tapping screws (see Figure 5.10).

5.Reinstall the Exhaust Shield.

1 2 3 4 5

S E TTIN G S

1 2 3 4 5

Figure 5.10

	V1			H1 Maximum		V2	V1 + V2 Min.
Elbow only				2 ft.	610 mm	*	*	*
6 in.		152 mm		6 ft.	1.8 m	*	*	*
2 ft.		610 mm		11 ft.	3.4 m	*	*	*
3 ft.		914 mm		16 ft.	4.9 m	*	*	*
4 ft.		1.2 m		20 ft	6.1 m	*	*	*
		V1 + V2 + H1		= 50 ft (15.2 m) Maximum
*No specific restrictions on this value EXCEPT
	V1 + V2 + H1		cannot exceed 50 ft (15.2 m)

Figure 5.11

16 Heat & Glo • 6000G, 6000G-IPI • 2103-900 Rev. M • 9/08