2 Getting Started
A. Design and Installation Considerations
Note: This appliance must be installed outside.
CAUTION
Check building codes prior to installation.
•Installation MUST comply with local, regional, state and national codes and regulations.
•Consult insurance carrier, local building, fire officials or authorities having jurisdiction about restrictions, installation inspection, and permits.
When planning an appliance installation, it’s necessary to determine the following information before installing:
•Where the appliance is to be installed.
•Gas supply piping.
•Electrical wiring.
•Framing and finishing details.
C. Inspect Appliance and Components
WARNING
Inspect appliance and components for damage. Damaged parts may impair safe operation.
•Do NOT install damaged components.
•Do NOT install incomplete components.
•Do NOT install substitute components.
Report damaged parts to dealer.
•Carefully remove the appliance and components from the packaging.
•The gas logs may be packaged separately and must be field installed.
•Report to your dealer any parts damaged in shipment, particularly the condition of the glass.
•Read all of the instructions before starting the installation. Follow these instructions carefully during the installation to ensure maximum safety and benefit.
B. Tools and Supplies Needed
Before beginning the installation be sure that the following tools and building supplies are available.
Reciprocating saw | Framing material |
Pliers | Hi temp caulking material |
Hammer | Gloves |
Phillips screwdriver | Framing square |
Flat blade screwdriver | Electric drill and bits (1/4 in.) |
Plumb line | Safety glasses |
Manometer | Voltmeter |
Tape measure | Level |
1/2 - 3/4 inch length, #6 or #8
WARNING
Hearth & Home Technologies disclaims any responsibility for, and the warranty will be voided by, the following actions:
•Installation and use of any damaged appliance or vent system component.
•Modification of the appliance or vent system.
•Installation other than as instructed by Hearth & Home Technologies.
•Improper positioning of the gas logs or the glass door.
•Installation and/or use of any component part not approved by Hearth & Home Technologies.
Any such action may cause a fire hazard.
Heat & Glo LifeStyle Collection • Dakota | 5 |
