Manuals / Heat & Glo LifeStyle / Household Appliance / Indoor Fireplace

Heat & Glo LifeStyle ST-42TVFL-IPI Vent System Attachment, 4 FT, Minimum, Maximum Horizontal Run

Models: ST-42TVFL-IPI

1 27

Page 14

	4 FT.
	MINIMUM
	MAXIMUM HORIZONTAL RUN
	17 FT.
	MAXIMUM
	10 FT.
	MINIMUM
	4 FT
	MINIMUM
Figure 6.	Vent System Attachment

WARNING: THIS GAS FIREPLACE ! MUST NEVER BE VENTED BY

CONNECTING TO A CHIMNEY FLUE SERVING A SEPARATE SOLID FUEL BURNING APPLIANCE.

Heat & Glo • ST-42TVFL-IPI • 455-902 Rev. C • 12/07

Page 14

Image 14

Heat & Glo LifeStyle ST-42TVFL-IPI owner manual Vent System Attachment, 4 FT, Minimum, Maximum Horizontal Run, 10 FT, 17 FT

Contents

Model ST-42TVFL-IPIWhat to do if you smell gas THIS UNIT IS NOT FOR USE WITH SOLID FUEL SAFETY AND WARNING INFORMATIONOwners Guide Table of Contents at Depot Service PartsStocked ST-42TVFL-IPIST-42TVFL-IPI Service PartsIPI Valve Assembly StockedMODEL and CodesApprovals and Codes TYPEGetting Started Pre-installationPreparationIntroducing the Heat & Glo Gas Fireplaces ANY SUCH ACTION MAY POSSIBLY CAUSE A FIRE HAZARDFigure 1. Diagram of the ST-42TVFL-IPI Locating the Installing the FireplaceStep FireplaceStep Framing the Fireplace Figure 4. Framing DimensionsStep Negative Pressure Make-upAir DUCT COLLAR Air DamperFigure 5. Make-upAir DAMPERWARNING YOU MUST NOT EXCEED THESE PARAMETERS Step Installing the Vent SystemA. Vent System Approvals WARNING YOU MUST NOT EXCEED AMINIMUM Vent System Attachment4 FT MAXIMUM HORIZONTAL RUNNOTE THERE SHOULD BE A 5 FOOT 60” C. Bedroom Installation in CanadaD. Vent Termination Figure 7. Vent TerminationFireplace Step Positioning Leveling, and Securing theStep The Gas Control System Figure 8. Proper Positioning, Leveling, andStep The Gas Supply Line Pressure Step Gas Pressure RequirementsFigure 9. Gas Supply Line Natural GasWall Switch Step Wiring the FireplaceOptional Accessories Appliance RequirementsShown with optional remote control receiver For Intermittent Pilot Ignition IPI WiringOperation using Battery Power Appliance RequirementsWall Switch Installation for Fan Optional Figure 11. Junction Box Wired to Wall SwitchStep Finishing Hearth Extensions Step Installing Trim Logs, and Ember MaterialInstalling the Trim Figure 13. Sealant MaterialSMALL GLASS TEMPERED GLASS SPECIFICATIONS LARGE GLASS TEMPEREDFigure 14. Placement of the Ember Material Placing the Ember MaterialReview safety warnings and cautions Lighting the Fireplace After the InstallationStep Before Lighting the Fireplace Step Double-checkfor faulty componentsSHUTTER SETTINGS MaintenanceMaintaining and Servicing Your Fireplace FireplaceContact Information

4 FT.

MINIMUM

MAXIMUM HORIZONTAL RUN

17 FT.

MAXIMUM

10 FT.

MINIMUM

Figure 6.

Vent System Attachment