NOTICE
-Replacement of the refrigeration cycle.
1.When replacing the refrigeration cycle, be sure to discharge the refrigerant system using a FreonTM recovery System.
If there is no valve to attach the recovery system, install one (such as a WATCO
2.After discharging the unit completely, remove the desired component, and unbrace the
3.Solder service valves into the
4.Solder the
5.Evacuate as follows.
1)Connect the vacuum pump, as illustrated Fig. 35A.
2)Start the vacuum pump, slowly open manifold valves A and B with two full turns counterclock- wise and leave the valves closed.
The vacuum pump is now pulling through valves A and B up to valve C by means of themanifold and entire system.
CAUTION: If high vacuum equip- ment is used, just crack valves A
and B for a few minutes, then open slowly with the two full turns coun- terclockwise. This will keep oil from foaming and being drawn into the vacu- um pump.
3)Operate the vacuum pump for 20 to 30 minutes, until 600 microns of vacuum is obtained. Close valves A and B, and observe vacuum gauge for a few minutes. A rise in pressure would indicate a possible leak or moisture remaining in the sys- tem. With valves A and B closed, stop the vacu- um pump.
4)Remove the hose from the vacuum pump and place it on the charging cylinder. See Fig. 35B. Open valve C.
Discharge the line at the manifold connection.
5)The system is now ready for final charging.
6.Recharge as follows :
1)Refrigeration cycle systems are charged from the
2)Connect the charging cylinder as shown in Fig. 35B.
With valve C open, discharge the hose at the manifold connection.
3)Open valve A and allow the proper charge to enter the system. Valve B is still closed.
4)If more charge is required, the
5)With the unit running, open valve B and add the balance of the charge.
a.Do not add the liquid refrigerant to the Low- side.
b.Watch the
c.Turn off valve B and allow pressure to drop.
d.Repeat steps B and C until the balance of the charge is in the system.
6)When satisfied the unit is operating correctly, use the
Service Manual 20