Features & Benefits
Cabinet
•Minimal height of the low profile series makes it ideal for low ceiling coolers
•Cabinet design features front access panels on each side for easy access to electrical and refrigeration components
•All electrical components factory wired to terminal board and identified, making it easy to field wire the unit
•Sweat connections to reduce potential for leaks
•Internal panels are isolated for quiet operation
•Liquid line solenoid wire harness is
•
Coil
•Internally enhanced tubing and fin design for higher efficiency
•Coil heater slots have been enlarged for easier installation and replacement
•Reduced heater wattages
•Hot gas loop on bottom of coil for easier access is standard for hot gas defrost models
•Fixed defrost termination for electric, adjustable defrost termination for hot gas
Drain Pan
•Large diameter drain hole (3/4" ID) is located on the back of the unit
•Extended drain pan heaters for more uniform defrost throughout the drain pan and additional heat in end compartments
•On
Motors
•Motors plug into wiring harness for easier servicing
•EC motors available
•PSC and PSC (Totally Enclosed) motors for 115/1/60,
•PSC motors or EC motors required for 50 Hz operation
Options
•Unit Configurations: mounted components,
-Units available with mounted TXV and mounted TXV / solenoid valve
-
-
-Various room thermostat variations including rear mount and front access versions
-Beacon II units come with electronic expansion valves, pressure transducer, temperature sensors and Beacon control board
•Most models available with glycol circuiting (see glycol product brochure)
•Units available with stainless steel housing and drain pan
•Units available with copper fins. Air defrost units also available with polyester coated fins or various coil coatings options
•Units available with insulated drain pan