Heath Zenith 2LBL3 Bulb Installation, Mount the Light Control, Wire the Light Control, Mounting

Bulb Installation

NOTE: When re-lamping, turn power off and let the fixture cool.

❒To remove lamp shade, loosen set screw 2 full turns with a small flat-head screwdriver.Turn shade counterclockwise and remove.

❒To remove bulb, pull straight out of fixture.

❒To replace bulb, push bulb pins into lamp socket. Check that the bulb is seated properly.

❒To reinstall lamp shade, place shade on fixture and align notches on shade with tabs on fixture. Turn clockwise. Tighten set screw firmly.

Mount the Light Control

❒Place the mounting bolt through the front of the junction box cover. Push the small gasket hole over the mounting screw.

❒Make sure the wire connectors and wires are inside the junction box. Align the mounting screw with the center hole in the mounting strap.Secure the fixture to the mounting strap.

❒Push the rubber plug firmly into place.

❒If a wet location junction box was not used, caulk the wall plate mounting surface with silicone weather sealant.

Wire the Light Control

WARNING: Turn power off at circuit breaker or fuse.

❒ Remove the existing light fixture.
❒	Install the mounting strap as shown using two screws
	that fit your junction box.
❒	The plastic hanger can be used to hold the fixture
	while wiring. The small end of the plastic hanger

Lamp Shade

Lock Nuts

Set Screw

can be threaded through the hole in the center of

the cover plate. The small end then goes into one

of the slots on the mounting strap.

❒ Route the light control’s wires through the large

gasket holes.

❒ Twist the junction box wires and fixture wires together

as shown. Secure with wire connectors.

Mounting
	Black to	White to
Strap	Black	White

Rubber

Plug

Gasket
Junction box ground wire to	Mounting
green ground screw on fixture.	Bolt

Keep lamps at least 2" (51 mm) from the sensor and 2" (51 mm) from combustibles.

❒Adjust the lamp holders by loosening the lock nuts, but do not rotate the lamp holders more than 180° from the factory setting.

❒Adjust lamp shades by loosening the set screws several turns, turn shades counterclockwise and remove.Reinstall the shades in the desired position and tighten set screws.

598-1325-00