Heath Zenith 2LBL3, 2LBL4 Specifications, Troubleshooting Guide, Year limited warranty

Time Delay . . . .

DualBrite® Timer. .

Replacement lamp. .

SPECIFICATIONS

Horizontal Range. . . Up to 70 ft. (21 m); 100 ft. (30.5 m) with Range Boost. [varies with surrounding temperature]

Vertical Range. . . . Up to 15 ft. (4.6 m)

Sensing Angle. . . . Up to 240° horizontal. Up to 80°

Vertical

Electrical Load. . . . Up to 200 Watts Maximum In- candescent (Up to 100 Watts Maximum each lamp holder.)

Power Requirements. 120 VAC, 60 Hz

Operating Modes. . . TEST, AUTO and MANUAL

MODE

. 1, 5, 20 minutes

. Off, 3, 6 hours, Dusk-to-Dawn T4 100W, G8 halogen bi-pin 120

VAC

TROUBLESHOOTING GUIDE

SYMPTOM	POSSIBLE CAUSE
Lights will	1.	Light switch is turned off.
not come	2.	Light is loose or burned out.
on.	3.	Fuse is blown or circuit breaker is turned
		off.
	4.	Daylight turnoff is in effect (recheck after
		dark).
	5.	Incorrect circuit wiring, if this is a new
		installation.
	6.	Re-aim the sensor to cover desired area.
Lights come	1.	Light control may be installed in a rela-
on in day-		tively dark location.
light.	2.	Light control is inTest.(Set control switch
		to an ON-TIME position).
Lights come	1.	Light control may be sensing small
on for no		animals or automobile traffic (re-aim
apparent		sensor).
reason.	2.	Range is set too high. (Reduce Range
		setting).
	3.	DualBrite® Timer is on.
Lights turn	1.	Sensor is in a relatively dark location.
off too late		(Relocate sensor, or use 3 hr or 6 hr
in Dusk-		setting).
to-Dawn
setting.

SYMPTOM	POSSIBLE CAUSE
Lights stay	1.	A lamp is positioned too close to the
on continu-		sensor or pointed at nearby objects
ously.		that cause heat to trigger the sensor.
		(Reposition the lamp away from the
		sensor or nearby objects).
	2.	Light control is pointed toward a heat
		source like an air vent, dryer vent, or
		brightly-painted heat-reflective surface.
		(Reposition sensor. Reduce Range).
	3.	Light control is in Manual Mode. (Switch
		to Auto).
Lights flash	1.	Heat or light from the lamps may be
on and off.		turning the light control on and off.
		(Reposition the lamps away from the
		sensor).
	2.	Heat being reflected from other objects
		may be affecting the sensor. (Reposi-
		tion sensor).
	3.	Light control is in the Test mode and
		warming up.(Flashing is normal under
		these conditions. Turn Boost off).
Lights flash	1.	Sensor is detecting its own lights.
once, then		(Reposition lamps to keep area below
stay off in		the sensor relatively dark).
Manual Mode.

1 Year limited warranty:

Should this product fail to perform satisfactorily due to a defect or poor workmanship within one year of date of purchase, return it to the place of purchase and it will be replaced, free of charge. Incidental or consequential damages are excluded from this warranty. Light bulbs are not covered.

Manufactured for Grainger International, Inc.

Lake Forest, IL 60045

598-1325-00