Heath Zenith manual Motion Sensing Halogen Fixture, Operation, Model SL-5525, Features, Lamp

Motion Sensing Halogen Fixture

OPERATION

Mode:	On-Time:	Works: Day	Night
Test	5 Sec	x	x
Auto	1, 5, 10 min.		x
Manual	Until Dawn*		x

* resets to Auto Mode at dawn.

Note: When first turned on wait about 1 1/2 minutes for the circuitry to calibrate.

Model SL-5525

Features

¥ Turns on lighting when motion is detected.

¥ Automatically turns lighting off.

TEST

Put the ON-TIME switch on the bottom of the sensor in the TEST position.

ON-TIME

10 5 1 TEST

¥ Photocell keeps the lighting off during daylight hours.

¥ LED indicates motion was sensed (day or night).

This package includes:

Plastic Hanger

AUTO

Put the ON-TIME switch in the 1, 5, or 10 minute position.

MANUAL MODE

ON-TIME

10 5 1 TEST

6 Screws	Gasket
(3 sizes included)
	1 Halogen
	Lamp
	Sensor
3 Wire
Connectors	Mounting Strap Light Control

Manual mode only works at night because daylight returns the sen- sor to AUTO.

Flip the light switch off for one sec- ond then back on to toggle between AUTO and MANUAL MODE.

Manual mode works only with the ON-TIME switch in the 1, 5, or 10 position.

1 Second OFF

then...

... back on.

Mounting Bolt

Rubber Plug

Light Shield

Requirements

¥The Light Control requires 120-volts AC.

¥If you want to use Manual Mode, the control must be wired through a switch.

•Some codes require installation by a qualified electrician.

¥This product is intended for use with the enclosed gasket and with a junction box marked for use in wet locations.

Mode Switch Summary

	TEST	Move ON-TIME Switch to
			1, 5, or 10 minutes
	AUTO			Flip light switch off
				for one second
				then back on*
MANUAL MODE

*If you get confused while switching modes, turn the power off for one minute, then back on. After the calibration time the control will be in the AUTO mode.

© 2004 DESA Specialty Productsª 595-5295-11