enny | OEI | 301l3~2l303 |
(~o~ti~ue~)
If shortening is slow coming from faucet, it is possible that the filter connecting the union on the filter tube line is not tightened properly. If so, turn off the pump and use gloves to tighten the union. This union will be hot. Severe burns could result.
e. Wash down and scrub the sides of the frypot.
f.After the sides and bottom are cleaned, open the drain valve.
7.Pump all of the shortening out of the filter pan and back into the cookpot.
8.When the pump is pumping air only, move the pump switch from PUMP to OFF.
9.Check the level of the shortening in the cookpot. Add fresh shortening if necessary, until it reaches the level indicator line on the rear wall of the cookpot.
Approximately 10 to 12 filterings can be made with one filter paper envelope, depending on several conditions; the quan- tity and type of product fried and filtered, the type of breading used, and the amount of crumb accumulation left inside the filter drain pan. When the filter screen assembly and filter paper become clogged and the pumping flow rate slows down, clean the screen assembly and change the filter envelope.
10.If frying is to be continued at this time, move the main power switch back to the “ON” position, and allow time for reheating of the shortening.
The following steps will help prevent filter pump problems.
1.Make certain the filter paper envelope is properly in- stalled over the filter screens. Make sure the open end of the envelope is properly folded over and clamped in place with the retaining clips so that the envelope is sealed and crumbs cannot enter.
I
2.Make sure all the shortening has been pumped from the filter lines and the pump by allowing the filter pump motor to run until no shortening is coming from the
nozzle. | |
|
