Henny Penny 580 manual

rior to servicing the solenoid valve, it is necessary to remove the side panel on the right side of the unit.

1.Remove the “tru-arc” retaining clip on top of the coil housing.

2.Remove the cover.

3.If only the coil is to be replaced, disconnect the two coil wires at the wire nuts in the coil housing.

insert new coil, and connect the wires at the wire nuts. Assemble in reverse order of disassembly.

The wires may be connected in any order.

4.Loosen the screws on the strain relief and pull the wires through the relief.

5.If the core-disc assembly is sticking due to build-up of shortening, breading, and food particles, proceed with the following steps:

a.Unscrew the solenoid bonnet assembly from the solenoid valve body.

emove the solenoid bonnet assembly and bonnet gasket.

c.Remove the core-disc assembly, core spring retainer, and the core spring.

d.ash all these parts in hot water.

If Teflon seals need to be replaced, proceed to Step 6; otherwise, assemble in reverse order of disassembly. Assemble valve core and blade with smooth side and rounded edge of blade toward the disc spring guide.

6.A repair kit (Part No. 17120) is available if any of the seals must be replaced. If any one seal is defective, they all should be replaced.

Solenoid body must be removed from the fryer for replacement of seals.