Henny Penny CW-114, CW-216 warranty WATER SUPPLY CONNECTION Continued, Light Bulbs And Glass Panels

Model CW-216/CW-114

2-8. WATER SUPPLY CONNECTION (Continued)

This unit as manufactured requires the installation of an appro- priate back-siphoning device (as per National Plumbing Code ASA-A40:8-1955) to be connected to the water inlet line.

This device to be connected in accordance with basic plumbing code of the Building Officials and CodeAdministrators Interna tional, Inc. (BOCA), and the Food Service Sanitation Manual of the Food and DrugAdministration (FDA).

Install a water shut-off valve in a convenient location.

2-9. LIGHT BULBS AND

GLASS PANELS

Step 2

Step 1

1.Cut the tape holding the doors shut and remove all boxes and boxes and packing. One carton contains the glass panels and the other contains the light bulbs.

2.Install the light bulbs and glass panels.

3.The unit is now ready to be cleaned per instructions in the Operations Section of this manual.

Replacing Light Bulbs

Light bulbs and glass may be hot. Severe burns could result.

1.Remove the glass panel by carefully pushing up on back of panel and sliding away from you. The panel will fall into your hand. See photo at left.

2.Remove the light bulb.

3.Replace the light bulb with a Westinghouse #60A19/35, 130 Volt bulb.

If this bulb is not available, a standard 60 watt bulb will work until a long life bulb can be obtained.

4.Replace the glass panel.

2-6 203