Hitachi 232133 manual Table of Contents, Symbols

Table of Contents

Warnings	. 2	Power Supply Cord	25
Component Function and Identification	. 5	On/Off Switch	25
Setup	. 6	Drive Housing, Connecting Rod, Crankshaft	26
Startup	. 9	Pressure Transducer	28
Shutdown and Care	11	Pressure Transducer Seal	28
Flushing	12	Suction Hose	29
Troubleshooting	14	Drain Valve	30
General Repair Information	19	Complete Sprayer Parts	32
Motor Test	20	Technical Data	31
Motor Brushes	21	Dimensions	31
Displacement Pump	22	Accessories	31
Motor	23	Graco Warranty	36
Motor Control Board	25	Phone Number	36

Symbols

Warning Symbol

WARNING

Caution Symbol

CAUTION

This symbol alerts you to the possibility of serious injury or death if you do not follow the instructions.

This symbol alerts you to the possibility of damage to or destruction of equipment if you do not follow the instructions.

WARNING

INSTRUCTIONS

EQUIPMENT MISUSE HAZARD

Equipment misuse can cause the equipment to rupture or malfunction and result in serious injury.

DThis equipment is for professional use only.

DRead all instruction manuals, tags, and labels before operating the equipment.

DUse the equipment only for its intended purpose. If you are not sure, call your distributor.

DDo not alter or modify this equipment. Use only genuine Graco parts.

DCheck equipment daily. Repair or replace worn or damaged parts immediately.

DDo not exceed the maximum working pressure of the lowest rated system component. Refer to the Technical Data on page 31 for the maximum working pressure of this equipment.

DUse fluids and solvents which are compatible with the equipment wetted parts. Refer to the Tech- nical Data section of all equipment manuals. Read the fluid and solvent manufacturer’s warnings.

DDo not use 1,1,1–trichloroethane, methylene chloride, other halogenated hydrocarbon solvents or fluids containing such solvents in pressurized aluminum equipment. Such use could result in a chemical reaction, with the possibility of explosion.

DDo not use hoses to pull equipment.

DRoute hoses away from traffic areas, sharp edges, moving parts, and hot surfaces. Do not expose Graco hoses to temperatures above 82_C (180_F) or below –40_C (–40_F).

DDo not lift pressurized equipment.

DComply with all applicable local, state, and national fire, electrical, and safety regulations.

2308801