LAMP REPLACEMENT

LAMP REPLACEMENT

6.Without installing the lamp cover, the power will be off and the Lamp Indicator will flash (see page 8). Be sure to install the lamp cover by re-engaging the two clips and tighten the screws before turning the power on, otherwise it may cause unusual colors.

SCREW

LAMP COVER

PHILLIP HEAD

SCREW DRIVER

NOTE: IF POWER IS CONNECTED BEFORE THE LAMP COVER IS INSTALLED, THE POWER WILL BE OFF AND THE LAMP INDICATOR WILL FLASH (SEE PAGE 8 ).

7.Install the front cover as shown below. Put the front cover back in and align the snap on quick connect then push inwards hold- ing the left and right side of the front cover until you hear a snap. Push the other snap on gently to make a good fit.

FRONT COVER

PUSH

PUSH

8. Plug power cord into AC outlet and turn on the main power switch.

120V

PUSH

POWER

NOTE: The lamp in this product contains Mercury. Dispose of properly in accordance with applicable environmental laws. For Recycling and Disposal information, contact your respective governmental agencies or the Electronic Industries Alliance at www.eiae.org (in the U.S.) or Electronic Product Stewardship Canada at www.epsc.ca (in Canada).

72

Page 72
Image 72
Hitachi 50V500, 60v500 important safety instructions 120V